Just fitting a rear dashcam, and having a difficult time refitting the rubber bit around the plastic insert in the body end.

 

Any tips?

 

Can the plastic insert be forced out? (Then fitted to the rubber grommet and pushed back in)?

 

Thanks.

That's how I did it on my Octavia...

 

Couple of tiny screwdrivers to pop the plastic end out, reseated the rubber over it and popped back in to place 👍

Do not break it! You cant buy it on its own and only comes as a complete tailgate loom, if its broken, water is going to get inside. 

 

The trick is with a tiny needle or pick to release one of the catches from the inside of the clip then gently pull it out, place the rubber gaitor back over it and click it back in.

And if you do break part of it like I did such that it won't hold in place stick it in position with windscreen sealant and close the hatch with some sponge or similar above it to hold it there until it's set.  You can then go round it with more sealant to ensure its watertight.

 

They occasionally leak anyway so the sealant might be a good precaution anyway.

Struggling to identify where the clips are. Haven't been able to find a pic of one removed on the internet.

They are along the two flat sides:

 

If I remember correctly, you need to attack them from the inside of the connector and tease them out the way:

 

Although I don't know what the access is like on a Superb...

Have only succeeded in bending one of the clips in further the wrong way. Currently trying to bend a hook into a metal skewer to try push it from the back that way.

 

Edit: metal skewer bent as shown worked perfectly.

Edited 24 July, 20223 yr by anewman
Update

Sorry to bring this thread back to life. How do you get the clip to move from inside the plastic bit? I have both ends of the rubber off on my Octavia vrs and it's been an absolute pain to to try and get it back on/in

I am sorry too,  to bring the thread back to life 1 year later.

After a successful rear dashcam fitting I broke the plastic bits under the rubber on kodiaq 2018 which they don't look like the onceon octavia. I was very careful but because the plastic is not flexible it broke easily.  It only cost £9 to buy but replacing it is an impossible task.  Any tips will be a tremendous help. 

Thank you. 

I tried to glue it to no avail, 

5 hours ago, rezki said:

I am sorry too,  to bring the thread back to life 1 year later.

After a successful rear dashcam fitting I broke the plastic bits under the rubber on kodiaq 2018 which they don't look like the onceon octavia. I was very careful but because the plastic is not flexible it broke easily.  It only cost £9 to buy but replacing it is an impossible task.  Any tips will be a tremendous help. 

Thank you. 

You’ll need to remove the loom, depin all of the connectors that go into the car side of it.

Feed the rubber off the ends, fit the new one and then repin the connectors.

 

Not an easy or quick job; that’s for sure!