Skip to content

Octavia2 2008 Front and rear parking sensors retrofit problem

Featured Replies

Hello there, 

 

i went through the whole topic regarding PDC retrofit but I am getting different results than what I should expect according to the hints here. 

 

My situation - I had old PDC unit with part number 1Z0919283B I want to add front parking sensors as well. So I bought front sensor loom, new bumper with sensors already fitted, button, speaker and fitted it into a car. 

 

New unit is 1Z0919475G and here comes the trouble - no matter how i try, no matter what i do, i cannot make car communicating with this unit. Tryed coding both addresses, tryed using connection to the actual CAN, then run new wires to the new CAN - no change. Then I swapped with new gateway - my actual one is 1K0907530Q, I swapped it with 7N0907530C also no change. When i use old can connections, it just downt want to work (no id of unit on diagnostics) when i switch to new can, i get multiple random errors from other units and also engine fan starts spinning. 

 

So my question is - what is a correct combination of this unit, gateway and CAN connection??

  • Author

ok... had to find solution by myself, its working now.

On 28/07/2024 at 10:01, CheeseMike said:

ok... had to find solution by myself, its working now.

For the benefit of members who find this thread in the future, can you say how you fixed it please.

 

  • Author

Problem was in interference on CAN bus - once I terminated old cut comfort CAN and run new CAN wires to drivetrain CAN it started working. 

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.