NobbyTucker

Answering my own question for anyone else down the line. It's 3T0521101A.

Hi all, I have just replaced my gearbox after a failure and it seems like the propshaft has rounded off and also needs replacing. Can anyone help me with a part number please? Thanks.

Here's a link to a YouTube video to remove.

That water must be going somewhere, just a question of finding out where. Keep topping it up and keep watching.

Apologies to @BryRod also asking, as I have similar problems if I may PM you good gents for the corect upgrade version number please? Here is my removed unit. Thanks

I removed my Superb glovebox a few years back using the Octavia video as a reference. It's very similar as far as I can recall.

Thanks. Mine are quite worn but it isn't triggered as yet. I'll hang on for a little longer as not making any noise at the moment .

Thanks for the helpful advice here and I have just bought a pair of Bembo discs and pads for my 4x4 Superb. One question,thinning discs and pads was picked up as a caution on my MOT. Are there wear warnings on the Superb or does it mean that mine are not working?

Update is Cruise control still not working. Latest VCDS scan not showing any faults. If I disconnect the battery, the CC will work for as long as I don't touch on/off controls or brake/clutch. Once I do it does not come back on. VCDS guy on here suggested that the battery could be the problem and thinking about it, when the Skoda one died during lockdown I swapped it for my 2 year old Toyota Avensis battery. Reading elsewhere on the forum posts suggest that a battery replacement needs recoding. Could this be my problem?

Mine is a Superb 2 2011 4x4, where the towbar came as standard. It's Westfalia and looks the same as yours.

It fails on switch on stalk, brake and clutch, but all test OK when operated on VCDS and shown no faults. I'm wondering if there is another all-powerful module I'm missing, which is the problem...? Thanks again.

I'm not sure ...I had a garage run a diagnostic test and forum member here run VCDS and both showed switches all OK. It doesn't seem to make any difference whether I switch the cruise control off and on again at the stalk, touch brake or clutch, it doesn't come on again. A non VW diagnostic test showed a 'steering module' fault, but the VCDS didn't. I might have to start randomly swapping out parts and if I do will start here, but not sure about that just yet. Thanks again.

Update - Still not fixed and any ideas very, very welcome! I bought a new Steering Column Module (clockspring) and took off the steering wheel, clockspring/module and stalk assembly. Tthe stalk assembly got stripped down and I checked the wires and contacts and cleaned both ends of the cruise control switch (stalk end and steering column end) and put it back. Then I stripped down the clockspring/module, checked and cleaned the ribbon, checked all wires and put that back. (I decided not to swap this out for the new one I bought as I thought I would need to reprogram this so instead I decided to check thoroughly first. Someone on here said the cruise control doesn't come through the clockspring - which seems to make sense). Each time I disconnect the battery and reconnect after and then the cruise control works once on and once off but no more. Another VCDS check shows no issues and testing individually the brake , clutch and cruise control switches and all are working with no issues. i am all out of ideas if anyone has any please?

Oh wow! That must have taken some finding and some sorting out. I'll read up on that too and check that tomorrow. Thanks.

Uh! No I didn't realise that! Is there somewhere else I need to check on the stalk then please?