GiscoYeti

Current software for HW 12 is SW 0330 installed and running, for HW 22 SW 0332, it is also important that OCU is at least at version 0139.

Ciao Have you update the OCU? TPI-2060553-8.pdf

Hi. At the moment the patches stop at MIB 2.5 the 3 is still unknown and armoured, better to make the updates at least to version 330

Hi great news I could not find version 332 Mib3 Skoda is it possible to have the link also in pm Thank you

Hello it is the petrol vapour recovery system with activated charcoal, the bottom tubes come from the tank the broken one from the intake manifold, it should not produce many vapours (injectors) but it would be advisable to change it to avoid problems

with this you will succeed!!!

Hello I beg your pardon, I am also in possession of a VCDS cable and if possible could you please post the step to do for crash signal verification? My OCU is 0139 and I should upgrade to 0143 but I am waiting until I am clear. Thank you Gianfranco

Hi as far as I know I have done two updates with USB (308-324)it is very likely that OTA happen by VIN, my Kamiq is MY20 (February) even though I had my system replaced and even though I installed SW0324 OTA update never seen, some of my friends with MY23 and SW0324 already got it. Thank you for your kind attention!! Gianfranco

Hi I did it like this

HI system information

Hi only the latest generation OBD2 adapters, and also a bit expensive, go into power saving I don't think Torque has the procedure except for the Phone, better disconnect it from the car !!!

Hi the Kamiq of 2021 with SW324 and HW22 update SW OTA, I saw you had an update for traffic signals so you may have these requirements!!!

Hi the extension cable may not have the correct pinout, you should check the connections on the car side and OBD dongle

Hi my support

Hi, the TPI I think is 2072245-5.pdf in Italian I attach the part about OCU 2. OCU ECU software update Before we start with the upgrade of the OCU ECU to SW 0143: - To upgrade to the new version SW 0143, first install SW 0088 in the OCU controller! If software 0083 is present in the OCU ECU, perform the upgrade according to task 91Y8 .

Hi, only with AFS Crystal Lightining i have this.

Effectively the OCU is closely connected to the radio/navigation unit as it acts as a "link" to the FEC and SWAP purchased in the purchase of the car (factory pack) I specify that my system is Amundsen 5F=3V0 035 816

First log with VCDS original Rosstech 16 Febb 2020

Hi,sorry to intervene,I have a Kamiq built in Jann 2020 and I post you the picture of my situation after TPI recall done in July 2020.

Good morning, sorry to intrude, I have a Kamiq style MY2020 and my OCU was upgraded for a recall in 2021 to H20 version 0139, I saw that there are two upgrades the 0141 and 0143, can I upgrade mine directly to version 0143 or upgrade first to 0141 as done for MIB3? Thank you for the kind response