I recently bought an octy vrs 1 and noticed the airbox has been changed as well as the dump valve therefore I think it's been remapped. Can I use the vag-com to find out if it has been remapped and if so how?

Thanks people

Take a look at boost pressures in blocks 115 and report back..

Full throttle, 3rd gear..

Kev

Take a look at boost pressures in blocks 115 and report back..

Full throttle, 3rd gear..

Kev

So it's ok to drive with the vag-com plugged in then? I'm basically borrowing a mates vag-com and will test over the weekend. What an amazing response time.

Thank

So it's ok to drive with the vag-com plugged in then? I'm basically borrowing a mates vag-com and will test over the weekend. What an amazing response time.

Thank

yeh, but don't sit with the laptop on your lap

yeh, but don't sit with the laptop on your lap

Last questions how do I get to find block 115 and is it software vcds 10.6?

Thanks loads people

go into control modules, then 01-engine, then click on measuring blocks, then type in group 115..

Cheers

Kev

go into control modules, then 01-engine, then click on measuring blocks, then type in group 115..

Cheers

Kev

Unfortunately my laptop bloody died. However on the first pressure reading i think it gave me about 1600 but I'm not 100% sure I got it right so I'm gonna do some more tests. Will report back soon. However, does 1600 sound right???

You need to log the boost readings for 115 and then look at the logs.

You cannot read VCDS while driving.

You need to log the boost readings for 115 and then look at the logs.

You cannot read VCDS while driving.

Ok I've got the log what exactly do you need from it, I.e. Certain measurements at certain rpm etc?

go into control modules, then 01-engine, then click on measuring blocks, then type in group 115..

Cheers

Kev

It ranges from 1600-1700 from 2500-6500 rpm