Hi,

Ages ago I remember somebody had gone to the trouble of creating an AutoCAD drawing of the MAP sensor mount to be used to relocate the mount onto a FMIC setup. If someone has this please could you PM it to me?

Thanks,

Tom.

Edited 19 August, 201015 yr by tom_beverley

I could do with this too!

why go to all that effort for CAD? its fairly simple to make from a peice of flat stainless? requires 3 holes and sealant. see mine below.

Just for ease really. I could send the dwg file to an engineering shop and get them to make it up whilst I'm on with something else.

Would be very handy if someone could forward one to me.

fair enough fella.... that part for mine took around 20-30 mins to fabricate FYI though.

fair enough fella.... that part for mine took around 20-30 mins to fabricate FYI though.

Reckon you can make me one up for some beer money? Just stainless or would a good grade ally be suitable? Wanting to use ally pipe thats all.

just the housing or the pipe too?

Just the sensor mount fella.

i'll PM u dude.

i have a forge map sensor pipe, brand new, 50mm 90 degree the one you get on the forge kit!!

mail me anyone

I have a couple of pictures of my diy cooler and maf sensor brackets if you need them. pm me if u want and I'll send them over

i have a forge map sensor pipe, brand new, 50mm 90 degree the one you get on the forge kit!!

mail me anyone

I will have that off you I can't pm you as my internet is down so I'm on my phone until its up again pm me your email address please so we can sort a price out :-)