Brand new Climatronic panel for heated seats 3TO 907 044 BS  £75 posted

 

 

Also Kufatec wiring loom (for seats with heated elements and electric lumbar adjust: just includes an extra few wires for a 12v power feed to the lumbar adjust: just don't connect these if you don't have lumbar on your seats).  £45 posted

 

Bought to connect the heating elements in my Audi seats but then realised I need load of extras as the Audi setup is different so given up gracefully..

Is this plug & play with a preFL Octavia, I have climatronic and heated seats ??

Doubt is completely plug and play. There is a bit of wire swapping to get the climate controls working: there is a thread in the Octavia 2 section.

For the seat heating there seem to be 2 different setups. Earlier cars have a heated seats control module (little black box) under both seats. Later cars have the module under just one seat (think its the passenger seat). My climatronic is for the later version. If you have the same I'd say it would probably work fine.

I'm interested in the control panel. Where are you based please?

Phil

Sheffield

Would you consider £65 posted?

Phil

Phil, Sorry for late reply.

 

I can do the panel for £70 posted if you can pay by paypal gift or bank transfer.  Paypal gift to:

 

davewoods3(AT)hotmail(DOT)com 

 

and BTW tried sending you a personal message but you can't receive messages apparently.

Hi, thanks. £70 sounds good to me.

I would prefer bank transfer of that's ok with you?

I have deleted some messages so hopefully pm's should work now.

Phil

Phil

Kufatec wiring loom (for seats with heated elements and electric lumbar adjust: just includes an extra few wires for a 12v power feed to the lumbar adjust: just don't connect these if you don't have lumbar on your seats).  £45 posted

 

 

 

So.. with the updated climate control unit.. with heated seat button.. could i retro fit heated seats with this loom ?

Have you still got it 

Sorry Tim: I did reply yesterday though my reply seems to have disappeared ..

 

I still have the Kufatec loom and 1 FL climatronic panel for heated seats.

 

Tim: you will need a climatronic panel, then the Kufatec loom which connects the panel to the seats (it terminates in a large black connector that exits the floor underneath the seats), then either heated seats from a donor car, or (if you are adding heated elements to your existing seats) heating elements and a bit of wiring underneath the seats and a 'heated seats control unit' that fixes to the underside of one seat. My Kufatec loom is for later seats (I think 2006 or 2007 onwards) with the heated seats control unit under just one seat. Dave

mine is a 2005 facelift octavia. not heated seats YET

so .. i could buy your loom then get donor seats from a 2007 model ?

Exactly: as far as I know you could.  You would need my loom and the FL climatronic panel.  I believe there is a little mod with swapping pins to get the FL climatronic to work in pre-FL cars: threads on here about it.  

 

Not sure if my loom would work with a pre-FL climatronic with heated seats buttons though.

Iv already got the newer control panel here to fit this week when the fascia turns up

would you take £40 posted ?

Sorry I'm not going to reduce it at the moment if I'm not selling the panel as well: might be harder to sell the panel on it's own. Did cost me £60 from Kufatec.

 

Dave

And I'm still half tempted to fit it myself..  ;-)

ok. £45 it is then

i would have had the panel too if id have realised last week b4 i purchased mine

Sent you PM

Kufatec loom is sold but climatronic panel still for sale.

Bump for the climatronic panel

Still for sale.

Climatronic panel still for sale.

How much for the panel ?