That's what I'm going to get. Black badges look good on my car. Wish id just ordered these, rather than attempting the plastidip.

http://pages.ebay.com/link/?nav=item.view&alt=web&id=221611507021

Just found these too

Sent from my iPhone using Tapatalk

 

 

There ya go...

Love the subtlety of the black vrs badge.

The rear one hasn't gone that well, it part peeled the first time, so really should have started from scratch again, but didn't. Ill have to re do the rear, weather permitting...

There ya go...

Very nice mate.

Sent from my iPhone using Tapatalk

The rear one hasn't gone that well, it part peeled the first time, so really should have started from scratch again, but didn't. Ill have to re do the rear, weather permitting...

Just of interest, what was the cause from it actually part peeling? Was this due to removing the masking tape/taping around the badge to cover your car up when plasti dipping or was it because it just peeled?

Just want to see what your experience was on it, before I either decide to buy black badges and take originals off or plasti dip them.

Sent from my iPhone using Tapatalk

Just of interest, what was the cause from it actually part peeling? Was this due to removing the masking tape/taping around the badge to cover your car up when plasti dipping or was it because it just peeled?

Just want to see what your experience was on it, before I either decide to buy black badges and take originals off or plasti dip them.

Sent from my iPhone using Tapatalk

I think I didn't leave it long enough to dry after spraying, so started to peel and didn't cut to the edge of the roundel, therefore I was left with a black inside and a silver ring round that. Decided it would be fine to then spray all over again without starting from scratch... and it wasn't. Be careful of the indents on the wing part of the emblem, as if not sealed with the plastidip, water can get behind and 'blow' it....

 

Regarding the VRS badge, I masked right up to the edge of that, as it has straight edges and it gives a clean finish.

There ya go...

Hey just wondering where did you get the black badges from also were they in a pair or did you have to buy them individually cheers

Replaced both front and back (obviously), plus debadged the back bar the VRS Logo.....

 

Bought both individually, http://www.superskoda.com/Skoda/OCTAVIA-III/Octavia-III-original-Skoda-MONTE-CARLO-black-emblem

 

 

Edited 16 May, 201511 yr by Nuriyan

Hey just wondering where did you get the black badges from also were they in a pair or did you have to buy them individually cheers

I sprayed them with Plastidip, its the standard badges underneath...