Hello, I have this adapter Link here

 

However we cannot connect the stereo. If we connect it directly the stereo is always on. Because of this I would neee the chart to see the ignitation etc wires. Does anybody have a picture that includes all wires connected in the car end

The stock headunit doesn't use a switched ignition feed so there isn't one.

 

You will need to run a new wire from the fusebox or use a CAN-bus adaptor

2 minutes ago, langers2k said:

The stock headunit doesn't use a switched ignition feed so there isn't one.

 

You will need to run a new wire from the fusebox or use a CAN-bus adaptor

Hey, the stock headunit was a skoda stream which automatically turned on when turning the key

Yes, the Stream turns on and off due to a CAN-bus message.

 

However, your aftermarket headunit needs a switched live as it won't support the CAN-bus message.

12 minutes ago, langers2k said:

Yes, the Stream turns on and off due to a CAN-bus message.

 

However, your aftermarket headunit needs a switched live as it won't support the CAN-bus message.

Can you link this? Where do I need to connect it?

4 minutes ago, TheCow said:

Can you link this? Where do I need to connect it?

I do not have any steering wheel controls.

In the picture from the website you linked, you can see a red wire coming off the black 8 pin connector that goes nowhere.

 

You need to extend the red wire to the car fusebox and attach it to a switched live. A multimeter will help you find one...

It would help a lot if someone had a diagram for all the pins. Can't find any

Typical quadlock wiring on a MK2 Octavia:

 

Typical ISO wiring:

7 minutes ago, langers2k said:

Typical quadlock wiring on a MK2 Octavia:

 

Typical ISO wiring:

Is A7 +12 switched the ignition wire? Is it supposed to go somewhere in the UPPER chart?

Yes, A7 needs to be the switched ignition wire.

 

The stock Stream headunit does not use a switched ignition wire, because of this, the quadlock connector does not have one fitted.

 

You need to run a wire from A7 to a switched ignition feed, the best location is the fuse box.

On 07/07/2020 at 18:44, langers2k said:

Yes, A7 needs to be the switched ignition wire.

 

The stock Stream headunit does not use a switched ignition wire, because of this, the quadlock connector does not have one fitted.

 

You need to run a wire from A7 to a switched ignition feed, the best location is the fuse box.

Old post but my fuse box is 12v constant, any other suggestions for ignition feed. Cig lighter is constant too

12 hours ago, Davieduck said:

Old post but my fuse box is 12v constant, any other suggestions for ignition feed. Cig lighter is constant too

 

There are definitely switched lives in the fuse box...

 

I assume you're checking the one at the end of the dash panel?