Hi all,

recently purchased a 54 fabia vrs. One issue with it was the fuel door not locking, and after having a look on this lovely website I could see this is a common issue where a little cable has come out. Pulled aside the carpet and sure enough it had come out. However, when I locked and unlocked the car, nothing appeared to happen? I would expect the cable to retract and compress the spring, which it is not. Having the spring extending is making it impossible to replace the cable, so I’m wondering if this is defective, or I just need to use some more force 

Hi, the cable has a 45 degree slope on its end.You need to make sure it is the correct way round when you put it into the plastic holder.There are 2 small fragile slots on the end of this housing,with 2 corresponding pegs on the cable end.Make sure these are engaged correctly. There is a fix on here if these slots have broken. It uses small cable ties to hold cable and housing tightly together.I would not use glue,because you may have to separate at some time.

Edited 19 November, 20205 yr by AndyPandy
added words

23 minutes ago, AndyPandy said:

Hi, the cable has a 45 degree slope on its end.You need to make sure it is the correct way round when you put it into the plastic holder.There are 2 small fragile slots on the end of this housing,with 2 corresponding pegs on the cable end.Make sure these are engaged correctly. There is a fix on here if these slots have broken. It uses small cable ties to hold cable and housing tightly together.I would not use glue,because you may have to separate at some time.

Didn't have it oriented properly - cheers!

I can now see the little locking part retract, but the door still doesn't 'spring' open so when the fuel door handle is released, it just re locks. Any ideas? Grow an extra long limb to pull the flap and release level simultaneously? 

I can only think of lubricate the hinges and the lock

Remember to fix the problem. I did a cable tie fix and it never happened again. The thread is too old now. But it was a common issue the cable coming adrift. 

On 19/11/2020 at 16:44, gav_is_con said:

Remember to fix the problem. I did a cable tie fix and it never happened again. The thread is too old now. But it was a common issue the cable coming adrift. 

Have now stuck a zip tie around, hopefully it'll stay.

On 19/11/2020 at 14:17, AndyPandy said:

I can only think of lubricate the hinges and the lock

Doesn't seem to have done anything. I can see the door trying to open when I pull the release level, but it just isn't able to pop open without an extra pair of hands to give it a pull. I've checked and the locking part fully retracts as well, not sure what else I can try 

Watched a couple videos on this issue and seen the little metal spring of sorts in other cars seems to be permanently depressed on mine - will have a closer look tomorrow.

perhaps the spring is broken or jammed in a compresson setting?

On 23/11/2020 at 14:28, AndyPandy said:

perhaps the spring is broken or jammed in a compresson setting?

Spring was jammed all the way in, loosened the little screw and it popped itself back out! 

I've got a similar problem, what screw are you referring too? 

4 minutes ago, FaZzVRS said:

I've got a similar problem, what screw are you referring too? 

Inside the fuel cap, there's a screw on the left hand side that the spring was stuck behind