Howdy all.

 

Once again, I am looking for advice when it comes to my Fabia. Do you people know if these metal pedal covers would fit? 

 

https://www.ebay.co.uk/itm/144230528527

 

 

I thought, based on shape and rough size alone (and the description) that they'd fit, but I'd like to make sure.

 

Thanks in advance.

 

Ryan B.

They should fit fine Ryan. Put them in a bowl of boiled water out of the kettle to soften up the rubber before fitting them if they don't want to go on dry.

 

And obviously remember to take your old ones off first!😁

Thanks Rich!

 

11 minutes ago, HeavyMetalRich said:

And obviously remember to take your old ones off first!😁

 

I only have the standard pedal set without the covers since it's not a vRS. These just slip over, right?

5 minutes ago, AnnoyingPentium said:

Thanks Rich!

 

 

I only have the standard pedal set without the covers since it's not a vRS. These just slip over, right?

 

You'll see when you get them.

3 minutes ago, HeavyMetalRich said:

You'll see when you get them

 

That's the attitude I typically take with ordering most parts for this car. 

 

14 minutes ago, AnnoyingPentium said:

 

That's the attitude I typically take with ordering most parts for this car. 

 

 

In seriousness, you will need to take the existing rubbers off before you fit the new vRS ones.😁 

 

I would need to get a new set for mine. There's only a few bits holding the metal on the clutch pedal.

Edited 14 October, 20214 yr by HeavyMetalRich
Added info.

Once again, thank you very much!

2 minutes ago, AnnoyingPentium said:

Once again, thank you very much!

 

No bother at all. 👍

I'd be inclined to go for better quality (more expensive) ones. In my experience you buy Chinese (cheap) you buy twice

1 hour ago, paulkennedy said:

I'd be inclined to go for better quality (more expensive) ones. In my experience you buy Chinese (cheap) you buy twice

 

I'll give them a shot, and if it goes terribly then I'll give some breakers a ring. 

Those fit 100 percent fine. Same pedals I have in my monte as standard. The throttle pedal cover just goes over the standard one, but the brake and clutch pedal ones need to be removed before you put the new ones on. I've swapped my montes brake and clutch pedal ones for the normal ones, the sports pedals look lovely but I prefer the normal ones. I kept the throttle pedal though because it means I dont have to "kick" the pedal so far when i'm going down a gear. The cover has the effect of "lifting" the pedal closer to the height of the other pedals I found.

Thanks, DM! I'll be sure to keep that in mind.