The videos make it look so easy on an Up! On the Citigo, there seems to be no way to twist the casing, as it is 3-pronged, rather than round. There doesn’t seem to be anyway of releasing it. What am I doing wrong? 

Pre or post facelift Citigo?

 

This any good:- 

s

 

Thanks, AG Falco

 

2013 reg, this is one of the videos I’ve seen, but the housing isn’t the same. 

Any photos? 

Rule of thumb is from behind twist anticlockwise first to remove.

 

From my manual:-

 

''Replacing the bulb for daytime running lights and parking lights-
Variant 1 ( with H4 bulbs )
Fig. 175
Replacing the bulb for daytime running lights and parking lights
 Read and observe and on page 136 first.
› Turn the housing containing the bulb C anticlickwise.

» Fig. 173 on page 137 as far as the stop in the direction of the arrow 1

» Fig. 175 Remove the housing containing the bulb in the direction of arrow 2 . back.
› Change the bulb.
› Insert the housing containing the light bulb in the lamp housing in the opposite
direction to arrow 2 .
› Screw the housing in the opposite direction to arrow 1 until it clicks into
place.''

 

Thanks, AG Falco

On 16/04/2022 at 11:27, Rich77 said:

as it is 3-pronged

Is this the H4 headlight bulb in the centre of the headlamp assembly.

 

Is it this one:-

 

 

Thanks, AG Falco