Hi, i Recently installed an OEM Reverse camera on My skoda Karoq from 2021. I am now trying to figure Out how to use My Old OBD11 Adapter to Code it to get it to work. I am unsure if its a High or Low camera. I would assume its a High one.
I got it here https://skoda-zubehoershop.de/karoq/elektroinstallation/920/rueckfahrkamera-karoq

Also after following the Installation Instructions Carefully its asked me to Remove the Original Pin 64 on Plug A on the Body Controll Module and replace it with one from the Kit, and add The Original one to the Wireing harness from the kit. My Problem is That the Original one is missing in my Car, So i cant replace it. Is this an issue?
Hopefully someone Would be able to tell me What exact module, Byte and Bit to enable that would be Great!

I used the instructions from Skoda Octavia, I think for the MK3 version: https://www.youtube.com/watch?v=nS0rKMOjO-U MQB - chassis

VAG Coding

Karoq (NU) - Activate reversing camera (retrofit) - VAG C...

Purpose: To activate the rearview camera after installation (retrofit camera Low or High). Procedure: 1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug

Hello,
Quick question: were you able to access the quadlock connector from the back of the media unit without removing the glovebox or it's only available with the glovebox removed?
I have managed to remove the media unit but not entirely, just about 90% of it and I can not access the quadlock connector.

Thank you!

On 30/03/2026 at 09:30, Viorel_92 said:

Hello,
Quick question: were you able to access the quadlock connector from the back of the media unit without removing the glovebox or it's only available with the glovebox removed?
I have managed to remove the media unit but not entirely, just about 90% of it and I can not access the quadlock connector.

Thank you!

I had the same problem, had to remove glovebox as the wiring was too short to remove the mediia unit.