Skip to content

5Q0 612 041 BM Brake booster vacuum hose with a non-return (check) valve and pressure sensor

Featured Replies

Our Karoq 1.5l petrol 2018 60000 miles went for a service this week.

The report said "Vacuum hose off inlet manifold has damage to connector and will not clip into place. Advise this is replaced".

Car seemed to drive as per normal with this 'failed' part after service

The part has now been replaced - separate visit - part details off the bag are "5Q0 612 041 BM Brake booster vacuum hose with a non-return (check and pressure sensor".

So I am wondering how often this part fails and requires replacement?

Perhaps this connection tab suffered from plastic ageing?

Does this part require disconnection as part of a normal service which included the spark plugs so the plastic top engine cover has to come off, etc.?

Photos below/attached:

  • old part on the drive which shows is wiggly shape - yellow arrow indicating failed connector

  • offside of engine bay with hose identified in red

  • nearside of engine bay with hose identified in red. Yellow arrow indicates failed connector

  • failed connector, shown with red line - the 'push' tab seems to have broken and is missing

  • non failed connector with green showing the bit of the tab that has come off

image.png

image.png

image.png

image.png

image.png

Plastic became brittle and snaps. Nothing unusual.

I think that that reason is acceptable when a car part does not cost much, but once the cost reaches a certain level, owners have a right to expect that parts are fit for use - and fit for use over a reasonable period over time/miles. I'm guessing that this part cost roughly £200 from Skoda UK.

I replaced a Lambda sensor on my wife's 2015 VW Polo 1.2TSI this year at roughly 60,000miles, even although I was careful with the Lambda sensors connector support bracket, I broke a tang off it when removing the faulty Lambda sensor connector. I fitted a new support bracket this week and while removing the old bracket, I broke a tang of the "other" Lambda sensor mounting point, the new bracket only cost £6 I think, so no big deal - but that was due to the plastic becoming brittle with age and local heat. One annoying bit of this job was, the cable tie mounting that snaps into this bracket, partially broke up while I was removing it from the original bracket - again "not very suitable" plastic - the sort of thing that people used to complain about when buying/using stuff "made in China" - how standards have dropped in Europe, or even from suppliers that European manufacturers use!

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.