Ross...

Attached is the Alignment results from my Octavia.... Do they look right?

Car feels fine now...

Cheers

Dazz

Fook knows, I cant make head nor tail of that.

Try rhis..

Try again!!

SWScan00048.zip

:confused: Ross.. any better or still not understandable...

Also does the equipment manufacture look similar??

I don't understand the figures.. What should a Octy vRS figures be?

cheers

Dazz

p.s. the car is driving much better... handling is better...

but wheel bearing drone still on right hand sweeping roads....

Dazz, Jon posted scans of the technical data for the Octavia's running gear a while back. I have a hard copy and, from what I can make out, most of your settings are within the various limits. I will see if I can track the scans down for you.

PS The scans were in this thread but the links don't work any more. :(

PPS Dazz, go and speak to a Skoda dealer who will have access to up-to-date technical data for your car's running gear.

Powerstation did me a printed record of alignment before and after tweaking... All stuff about minutes and degrees... but I can't match any of that up to the scribbles on that sheet...

:confused:

Yeah it's amazing just how much Powerstation can alter on a car and the transformation in handling. Will be heading back there to get my springs and dampers fitted

Chris

OK. The relevant figures on the technical data which has now gone missing are:

Front sports suspension

Toe for 17" wheels (RS only) ... 0

Thanks all...

I have spoken to the Skoda dealer...Who assures me that all the measurements are within Skoda spec's There Techie's have checked it

closely.... Not that I'm doubting this BUT they supposedly checked it out

thoroughly before, when the tracking was out and the bent rear axle was

found.. So no confidence.. suprisingly!!

I might take this to another Skoda dealer to double check.....

Those scans will be very USEFULL..

Ta

Dazz... Should change my signature as my Skoda ain't bent anymore!!!

Still cannot make sense of it...

Thanks Denis.... But I need a technical description..

And a if these figures in my report cannot be understood by a techie..

then are they correct??

ROSS HELP!!

Cheers

Dazz

From what I can make out it looks about right, but to be frank any wheel alignment gear worth its weight should have a concise print out of before and after measurements rather than some scrawl on a bit of paper.