eBay Motors: REAR CAMBER TOE KIT AUDI TT QUATTRO A3 S3 VW R32 BORA (item 230193079790 end time Nov-24-07 07:49:35 PST)

If not, any suggestions where to get one that would?

thanks

Bas (slightly out of alignment at the rear )

i would have thaught you would have taken a quick look and knocked up a set of custom top adjusters before breakie,a man of your skills would have no probs:thumbup:

no that wont fit Basil

i think you will have to face up to the fact that you will have to get another beam , or live with what you've got

there may be enough movement at the beam front mounting bolts to get the distance between the front and rear wheels equal , but the camber and toe adjustment will be nigh on impossible to correct IMO

no that wont fit Basil

i think you will have to face up to the fact that you will have to get another beam , or live with what you've got

there may be enough movement at the beam front mounting bolts to get the distance between the front and rear wheels equal , but the camber and toe adjustment will be nigh on impossible to correct IMO

Larger Hammer needed?

Larger Hammer needed?

and Oxy-acetelene

sigh, alright - acceptance!.....

Either I live with it pulling to the left or swap the entire rear beam.

What pull to the left? - they all do that (denial).....

Thanks a lot guys!

Bas

the thing is Basil , you can get another beam , and that may have the same kink/bend/discrepancy in the alignment that the old one has , as that was how it was made at the factory , and it still gives the factory tolerances for the rear alignment

I like the idea of the oxy-acet. torch. Heat up the area opposite the direction of misalignment red-hot and then douse with cool water. Instant warpage! Complex metallurgy and heat treatment be damned...

And maybe have a go at heating up the fuel tank at the same time.....

(I'm only kidding - don't panic!)

Bas