FollowingGhosts

Stripping the turbo is the 'proper' way but if it's not too bad you can have some success with Mr Muscle. It may take one or two goes (3 or 4 in my case) but it is doable. If you look at the top of the engine, you'll see the EGR valve (looks a bit like a UFO), from the bottom of that there will be a metal pipe leading down and to the right to the top of the turbo with two 13mm bolts either side. That's the hole you're looking for. The bolts may need some persuasion after 14 years of being attached to the turbo and I'd highly recommend having some spares as you may well drop one and spares are pennies anyway. You can then just follow most of the guides that all go along the same lines: push the tubing down to the bottom of the turbo and fill it up gently, leave it for a couple of hours with some actuator wiggling every 10-15 mins. Make sure you have gloves on, Mr Muscle is nasty stuff, and make sure you have plenty of stuff to wipe it up with as it does tend to try and get everywhere and there are bits it won't do any favours for.

Mine has popped off in two spots before. Once on the bottom of the tank itself (remove wheel arch liner for that), the second time on the bulkhead

Hi all, I've got a 1.9tdi 2002 Estate with rear hand brake issues, the calliper is never disengaging properly but I don't think the cable is moving freely which isn't helping How does one go about replacing the cables? Do I need the car particularly high in the air to do it and what do I need to do? Thanks

For the sake of feeling sheepish, it'd help if there wasn't a massive hole in the vacuum line going to the turbo actuator. Tip: always double check the hoses

Went to see a T4 that I spotted on eBay today but that was a bust. it was a 1.9 that was apparently drinking water every so often (Not G12/G13, but water they'd been topping up with), had no service paperwork and no evidence for any oil changes in the last 6 years. I decided to leave it as there were too many unknowns and it didn't scream of being looked after. Are the later (2008+) connects any better than the early ones? They can be had for sensible money for the age and there are a few with FSH etc.

If it means I'll get something better/more reliable, I'm open to the notion of something Traffic/Transit sized. Basically my aims are 40+mpg extra urban, and fitting the bike in the back. The bigger it is, the more space I'll use. Though, LT35s are way too big for my road.

My biggest issue with the Kangoo/Berlingo/Combo is load length. The maxi versions would fit it but then I come into the issue of price as I'm not wanting to spend the earth and then some. Equipment isn't much of an issue. Remote central locking would be nice, and electric windows, but they're not dealbreakers. Ideally, budget is around £2500 for something that might be rough around the edges that I can tart up I've got to get a GS500 which is 2.08m long into the back of it.

The only thing with the caddies are they really push my budget. I'd have to settle for an SDI or a much more tired van than I could get equivalent connect for the same money. I could get a T4 but then I'm talking 90s-era everything and associated wear and tear. Are the connects really that bad? They seem to be fairly cheap

Realistically, the Furby is on it's way out anyway. It's got endless little niggles building up and was a dog car before I got it and I'm hesitant to keep pouring money in I've considered it, but they're coach built so insurance can be a bit of a pain can't it? also not sure a motorbike would fit in the back of it.

Hi all, Looking at small vans as an alternative to making my Fabia estate carry everything, and ideally need something I can get a motorbike in the back of. The main contenders for a couple grand seem to be: Ford Transit Connect (LWB should fit bike easily) VW Caddy (This might be a push) Vauxhall Combo (Not sure I have much chance) Kangoo/Berlingo/Partner (I've a feeling these are way too small) Bike in question is a Suzuki GS500 so not the smallest, but equally not the biggest either. Any recommendations, vans I've missed or general advice would be appreciated

Just been out for a run in my PD100 and even after 10 miles or so of motorway driving it wasn't quite up to temperature. I think the problem is it's a big engine that isn't necessarily worked that hard pottering around so it struggles to get toasty on all but long journeys with the heaters going. The bottom radiator hose was cold so it's not even that the thermostat. The water pump is a month old from VAG, done with the cam belt too so it's unlikely to be that.

So, replaced the vacuum solenoid box with one from a breakers. It didn't go into limp mode once on the motorway once this time. Even when I was in fifth and trying to coax it to. It seems to have more pull from the turbo too.

I followed the hose from the T off to the vacuum solenoid box and found that there is vacuum being held in the hose between the t-off and solenoid end However, if I remove the hose from the T-off and leave it attached to the solenoid box, the solenoid box isn't holding vacuum, if that makes sense

Thanks, just checked all my hoses and they're all holding 20inHg happily so I don't think it's them I've taken each hose off one by one. I took the hose off between the T-off for the master cylinder and the solenoid box and that wasn't holding vacuum when the engine is off. Is that normal or is that a sign the box is done for and needs replacing?

Bottom parts of the seat just lift out. The top parts you just need a screwdriver to release the catch holding them in place.