Brissy
Finding my way-
Posts
12 -
Joined
-
Last visited
Profile Information
-
Location
Brisbane
Car Info
-
Model
Octavia RS
-
Year
2012
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Brissy's Achievements
-
Brissy started following Rear wiper stopped working , 1.8 TSI Leaking Oil into Spark Plug, Needs New Engine or can I keep driving it and topping up with oil? , Possible oil leak and 4 others
-
Is the motor gone or is it jammed, the mec sticks. You can pull it apart and clean it.
-
Hi the client, I am having similar issues with my Octavia 2012 RS CCZA engine using oil. You mentioned the control ringdesign that is prone to blockage and failure, where would I find this?
-
Hi the rear left hand speaker cover is damaged, can any one please tell me if it is possible to just get the speaker cover or is it a whole new door card. thanks for any information
-
Fault code P0172, System too rich bank 1
Brissy replied to Brissy's topic in Skoda Octavia Mk II (2004 - 2013)
I have found an articulate about this code very good. https://mechanicbase.com/trouble-code/p0172/ -
Hi, I had engine light come on, fault code was P0172 system too rich bank 1. Also after to long runs it was missing a bit, any idea what this code is caused by. Thanks
-
Engine code and why it's useful to know
Brissy replied to Breezy_Pete's topic in Handy Topics & Guides
Some great info being posted, thanks it all helps use fix issues easier. can some one please suggest a engine code reader I should look at using, I have a Octavia RS 2012 MK1 -
Hi inspectorman the diagram you put up is great, would you possibly have one for a Octavia RS 2012 Mk1 or pointme in the direction to find it please? iam having a small issue with a smell of coolant,
-
The back door wasn’t closing properly, the latch had come loose. Adjusted and it was good.
-
I got it working thanks to those helpful people for parting with your knowledge. You have been a big help.
-
Thanks for your answers
-
Hi I am having the same problem, you have already swerved a few question. The unit works if I put power on it via the 2 out side pins. In the connector the 2 out side pins are 12v & negative is that correct, then the 2 middle pins are signalling as you pointed out ? How an I test if I am getting a signal? What is a canbus node and where would I find it? Or look like youhelp would be appreciated