mr_igor

Another question, do you have an ignition key/remote like this?

I wonder what this warning looked like... Didn't they take photos?

You need to walk along the entire length of the wire to the sensor, maybe it got pinched/twisted/broken somewhere during the clutch repair...

The range readings are calculated by the on-board computer (quite approximately) and depend on: fuel quality, instantaneous consumption, average consumption, road conditions, driving style, and...you can go on.

After buying a car, it makes sense to have it serviced and have a full diagnostic done. This way you will be sure that everything is fine with the car. IMHO.

Show me a photo of the panel that controls the climate. For me, pressing the right knob works.

Sometimes it's more convenient to build a route on your phone/computer and then connect it to your car. IMHO.

Maybe you should try connecting a scanner and see if there are any errors in the car? And in which blocks, otherwise you can guess for quite a long time...

https://www.klavkarr.com/location-plug-connector-obd/Skoda-kamiq-1

Under the small glove compartment to the left of the steering wheel, you can feel it with your hand.

Подскажите, есть ли фильтр/сеточка в заливной горловине омывающей жидкости? and if so, what does it look like?

In my car, the trunk light is like this (but I’m the second owner), does anyone else have a light like mine or is this an upgrade from the first owner? It is turned on by a button with a red backlight in a circle. Thank you!

As I understand it, everything worked out for you, is that so?

1. I updated immediately from 1310 to 1800 without intermediate updates. Everything became OK. 2. Use an OTG adapter and a 4 G flash drive (I did this) 3. Connect the charger to the car battery. When the voltage drops, the process may stall at an incomprehensible stage. 4. See point 1 – the whole process took about 20 minutes. 5. There is a file (MEN3_EU_SK370_P3355L_1800). Where to pour it?

I see this for the first time. I have a completely different one. And mine doesn't come off...

Can you take a photo of the lamp installed in the car?

There is always a pump or compressor in the car.

Taking into account that the width of the installed wheels and spare parts are the same, we will limit ourselves to a pressure of 2.5 bar. Phuhhhh. Got it figured out! Thanks for the advice!

It turns out you should read the inscriptions on the wheels. Here I found a specific answer to my question. I will follow the manufacturer's recommendations.

By the way, what pressure should be maintained in such a “dokatka”?

When I bought the car, it was equipped with such a set as shown in the photo 2 posts above, which I am immensely happy about! I don't trust repair kits.

My car has the 1800 version installed correctly download file (MEN3_EU_SK370_P3355L_1800) pass: 22822

Hello! There is such a file. Size more than 300 MB. How can I share it?