well peeps ive been playing around with some 90mm neoprine piping today from the maf to the top of the turbo,it was a 90mm down to the 80mm so was a bit of a squeeze on the pipe but it held on

the car seemed ok low down but opening up and over the 1** mph mark it felt sluggish and there was a bit of a splutter so i backed off

anyone got any ideas?

cheers

I can't see how changing the T.I.P can really affect the running so much. The only possible thing is maybe the MAF is seeing odd signals?

PS: Talking about exceeding 100mph is not wise!

Possibly sucked the pipe in shutting off the air supply a considerable amount?

Possibly sucked the pipe in shutting off the air supply a considerable amount?

This

cheers guys

it has the steel wire running through it but quite 'soft' inbetween

ill stick the old 1 back on

There isn't a massive amount of suction from memory, at least not enough to close up a neoprene pipe. Maybe it is closing it up enough to create a stutter/hesitation, which in itself means its not good. I have a custom TIP setup but its all done using ally pipes, and silicone bends.

There isn't a massive amount of suction from memory, at least not enough to close up a neoprene pipe. Maybe it is closing it up enough to create a stutter/hesitation, which in itself means its not good. I have a custom TIP setup but its all done using ally pipes, and silicone bends.

If I was doing my car, hard-piping would definately be the way I'd go!

There isn't a massive amount of suction from memory, at least not enough to close up a neoprene pipe. Maybe it is closing it up enough to create a stutter/hesitation, which in itself means its not good. I have a custom TIP setup but its all done using ally pipes, and silicone bends.

cheers for that m8

is there any chance you could give me some info what i need to buy etc

thanks

PS: Talking about exceeding 100mph is not wise!

He forgot to say he drove all the way to the autobahn to test it lol

or his private road own

was thinking of a 90mm stainless pipe 200mm long then 2 (1 on either side) silicone joiners

im not sure on the joiners though as the original hoses are 80mm so im thinking whether to go 90mm then clamp them down or 90-80mm reducers in silicone

any ideas?