hi all after end 50 km my car stop my car work like 2 slinder but i know i cant speed if  Pressure car brake the car stops vibrating as if one does not work cylinders, but I'm sure that the three cylinders working
What are the sensors, which can cause malfunction in the motor vehicle check fuses

 

help me plz

and sory my english is very bad

thx

karam

That engine is famous for burning out the exhaust valves causing a loss of compression, get your compression tested first.

first thx for replay

sorry bro but What do you mean about   compression

my english is very bad give me pic plz

Edited 14 December, 201312 yr by MohamedKaram

There is no picture for compression, it is the pressure in the cylinders when the engine is being turned over, it should be between 10 and 15 bar and all cylinders should read the same.

 

The sensor you could change is the engine coolant temperature sensor, then you could test the ignition system.

http://www.google.co.uk/imgres?safe=active&hl=en&biw=1600&bih=748&tbm=isch&tbnid=67z4jN5Mugt2dM:&imgrefurl=http://www.popularmechanics.com/cars/how-to/maintenance/cars-101-how-to-do-a-compression-test-14912158&docid=LNV6DHG2i_ytkM&imgurl=http://www.popularmechanics.com/cm/popularmechanics/images/Fr/compression-test-1212-de.jpg&w=300&h=300&ei=KHGsUsXVO4fD0QXSs4CQCA&zoom=1&iact=rc&dur=157&page=1&tbnh=141&tbnw=139&start=0&ndsp=35&ved=1t:429,r:9,s:0,i:108&tx=104&ty=81

 

the tester looks like the above link, screws in where your spark plugs are

Could be the spark plug coil pack?

 

Happened on my old 1.2 12v, complete loss of power but still drove.

 

Not very expensive if it is, needs fault code to be read to confirm

i set my car in multyscan computer cars

and give me this

engine oolant temp sensor ( g62) signal too high

i  Has been changed coolant temp sensor

 

but proplem stay

Where are you in the world?

Could be the spark plug coil pack?

 

Happened on my old 1.2 12v, complete loss of power but still drove.

 

Not very expensive if it is, needs fault code to be read to confirm

thx for replay

 

in multscan engine oolant temp sensor ( g62) signal too high

Where are you in the world?

iam frome egypt bro my english very bad.......

You need to clear the fault codes and reset the ECU to base map before the new temperature sensor will work properly.

You need to clear the fault codes and reset the ECU to base map before the new temperature sensor will work properly.

i do that but multscan gave me new masg

manful sensor hauprasher too high

 

wear is this sensor??????

Edited 14 December, 201312 yr by MohamedKaram

any budy hear???????

any one answer me plz

Manifold Absolute Pressure sensor reading too high?

Manifold Absolute Pressure sensor reading too high?

yes yes yes >>>>>>>>>

MAP sensor is located at the other side of the inlet manifold from the throttle body: No.8 in this image:

 

MAP sensor is located at the other side of the inlet manifold from the throttle body: No.8 in this image:

 

thx bro

iwill change it and iwill toald u

r u have map for all engine sensors?????? like this

thank you bro very thx