My new 15 plate VRS when going into reverse the parking sensor displays as normal and works ok, when I then go forward or out of reverse it takes a age to drop out of the display or turn off the beeps, so much so I end up cancelling myself. 

 

This never happened on my 14 plate elegance previously 

 

Any ideas what or why causing it 

 

Cheers Simon 

Reverse screen on mine also takes several seconds to disappear after I put into drive, but not sure about beeps.

Do you have front sensors as well? If so it sounds  normal for the display to stay on till your traveling forward at over 5mph or so, or switch it off yourself.

27 minutes ago, Kenny R said:

Do you have front sensors as well? If so it sounds  normal for the display to stay on till your traveling forward at over 5mph or so, or switch it off yourself.

No only rear and same setup in my Elegance previously, that's why thought it weird 

1 hour ago, Sparksuk71 said:

My new 15 plate VRS when going into reverse the parking sensor displays as normal and works ok, when I then go forward or out of reverse it takes a age to drop out of the display or turn off the beeps, so much so I end up cancelling myself. 

 

This never happened on my 14 plate elegance previously 

 

Any ideas what or why causing it 

 

Cheers Simon 

 

It’s normal for later models. The reverse screen now turns off when you exceed a certain speed. It can be changed with VCDS or similar. I think it’s just in case you roll back. You’ll now still get an alert if there is something behind you. 

15 hours ago, SC03OTT said:

 

It’s normal for later models. The reverse screen now turns off when you exceed a certain speed. It can be changed with VCDS or similar. I think it’s just in case you roll back. You’ll now still get an alert if there is something behind you. 

 

Thanks that makes a lot of sense

if you find the VCDS fix let us know, i have the same annoying issue, beeps and all.

4 hours ago, JohnnyType2 said:

if you find the VCDS fix let us know, i have the same annoying issue, beeps and all.

Hi not tried 

But found this, maybe the same place too look? 

 

https://www.t6forum.com/threads/turn-down-reverse-beeping.1176/

 

10

Ide01170 visual display maybe 

 

I only have obdeleven so unsure about long coding with that

i thinkyou can control the beep volume from the settings on the stereo. i would like to change how the time it takes to turn off from finishing manouvres.

2 minutes ago, JohnnyType2 said:

i thinkyou can control the beep volume from the settings on the stereo. i would like to change how the time it takes to turn off from finishing manouvres.

 

Hi yes that is what this thread is about but another search said it can be done in vcds so without being able to look I was hoping the delay was in one of these units and would second guess it was in visual display, but don't know without the tool 

 

Unfortunately I'm not a vcds expert either