On 02/01/2022 at 17:58, ApertureS said:

Ive ordered a genuine sensor aerial and im gonna mount that instead of an aliexpress special, then i will try your coding when it turns up and let you know. Thanks!!!! 

HI, Glade you have successfully make it work, Where and how much cost you geniune device? 

 

So for resume

You code the keysys and the virtual pedal only? 

On 03/05/2021 at 23:29, AlVal said:

Just to correct my earlier post about the wiring to KESSY pins, it should be pins 2 and 16 on KESSY. 

 

Also the holder bracket I bought from skoda to hold the module doesn't work because its designed for a skoda module, and the one in the Chinese kit is from a passat, must be a different shape. 

 

 

Can You send us all steps with coding the virtual pedal? 

so ApertureS how you solved 221445 - Sensor for rear lid/hatch opening - No calibration/Basic settings fault? just by changing sensors?

hi guys! I'm struggling to start Easy Go! My trunk lid controller is:

SW: 5Q0 959 107 AB HW: 5Q0 959 107 J

Component: HDSG-Modul H13 0272

I bought the entire set 565 962 235 E which included the 5NA962243B controller plus two glued-in antennas. I installed everything and connected it to the Kessy PIN 2 and 16

I did the coding (Kick-to-Open/Kick-to-Close Active etc.) in the 5th module!

I tested: ENG246994-Verdecksteuergerät-virtuells_pedal_version

version_1_2 - For most older installations (up to approx. 2020)

version_3 - For newer models/sensors after 2020 - a different way of communication

I activated all Virtual Pedal - Active options

It doesn't work and I have no errors and it doesn't open the flap with my foot!

Colleagues, can someone help with this topic?
Please, help me guys!

Try gluing the black strip, i.e. the sensor cable, to the top edge, right past the tow bar cutout. It's possible that the sensor won't respond if it's positioned down there. OEM doesn't do that either. Or swap both: black on the front, red on the back.

I have this error, everything is connected correctly, I've checked it twice. The sensor module in the bumper is new.

Address 05: Start Permission (J518) Label file:| 5Q0-959-435.clb

Component code SW: 3Q0 959 435 N HW: 3Q0 959 435 N

Component: VWKESSYMQB 037 1307

....

1 error found:

221700 - Rear cover opening sensor

B1303 31 [10001001] - No signal

MIL on - Confirmed - Tested since error codes were cleared

Freeze frame:

Error priority: 2

Error frequency: 1

Internal error counter: 79

Mileage: 178847 km

Date: 2025.06.09

Time: 18:31:49

Terminal_15_Kessy_specified_value: ON

Terminal_15_Kessy_actual_value: ON

Terminal_15_central electric_actual_value: ON

Terminal_15red_Kessy_specified_value: ON

Terminal_15red_Kessy_actual_value: ON

Terminal_S_Kessy_specified_value: ON

Terminal_S_central electric_actual_value: ON

Terminal_50_Kessy_specified_value: OFF

Terminal_50_Kessy_actual_value: OFF

ZAT_pressed: OFF

Range lever position: park: Unlocked and locked

Query active: Condition not met

Steering column lock unlock: Condition not met

Immobilizer unlock: Condition not met

No active fault mode: Condition met

Key signature validity: Condition met

Control Module Voltage: 12.136 V

Driver Information: Key Position Recall: Service: Disabled

Driver Information: Vehicle Rollback Warning: Disabled

Driver Information: Emergency Stop: Disabled

Internal_key_position: no_message

Driver Information: Comfort System Disabled: Disabled

Vehicle Speed: 0.0 km/h

Engine Speed: 0.0 /min

Vehicle Lock Status: Vehicle Unlocked

Inside Zoom: Disabled

Inside Start: Disabled

Outside Zoom: Disabled

Outside Start: Disabled

Outside Door Handle Actuator: Disabled

Code Information: Coded

Inside Zoom: Disabled

Inside Start: Disabled

Outside Zoom: Disabled

Outside Door Handle Actuator: Disabled

Code Information: Coded

Inside Zoom: Disabled

Inside Start: Disabled inactive

External zoom: inactive

External start: inactive

Exterior door handle linkage mechanism: inactive

Code information: Coded

Interior zoom: inactive

Interior start: inactive

Exterior zoom: inactive

Exterior start: inactive

Exterior door handle linkage mechanism: inactive

Code information: Coded

Driver door: Closed

Passenger door: Closed

Rear left door: Closed

Rear right door: Closed

Active_LF_scans: Init.

Sensor ID 1 identification: status: No response

Sensor ID 2 identification: status: No response

Sensor ID 3 identification: status: No response

Sensor ID 4 identification: status: No response

SPN_Byte 0: 00

SPN_Byte 1: 00

SPN_Byte 2: 00

Hi I’ve a 2024 mk3 superb combi in style spec (ireland) it’s got electric tailgate with keyfob and button by the gear selector for opening the powered boot. I’m unsure if this has virtual pedal I watched a vague Skoda YouTube video and followed instructions but the option doesn’t seem to be in the menu.

Thanks in advance.