Hi, I started installing cruise control for my 2013 Skoda Citigo with the Cum Cartec Kit, I have got to the point where I need to remove the lower dash trim in order to connect wires to the BCM but I am not able to do so. How do I remove the lower trim? I have pulled away 2/3 of the top clips but cannot see how to fully remove it. 

 

Any help is appreciated, thanks.

It took me over a year to figure out how to do it.  It's actually screwed in behind the trim panel under the radio. 

 

Take the screws out of the top of the glove box and the one ones behind the side panel too.  Then you'll able to drop the glove box down a few centimetres so you can pull out the centre piece of trim under the radio from the top.   Then you'll be able to access the rest of screws

I came across this very handy video when I needed to replace the blower resistor. Removing the dash is at the beginning.

https://youtu.be/vzL4PNxddyM

Edited 4 September, 20223 yr by thebrighton

Hi all, thanks to @thebrighton for the video link, I worked out that I had to take the panel off the side of the dashboard (facing the door) to get to 2 bolts that I hadn't undone before I could loosen the panel.