Anyone want to guess where I'm going tomorrow??

The Czech Republic.

Disneyland?!

I was actually going to say Lakeside, as you are in Essex.

But thought the Czech republic was far more interesting.

The dealer to complain about something?

Well its in daventry so not Czech or Disneyland as much as I'd love to go there

Daventry, I win

I'd be worried if you got it wrong after i said it haha. Anyone know what's in daventry??

Daventry, I win

Revo I'm guessing?

I'd be worried if you got it wrong after i said it haha. Anyone know what's in daventry??

Revo, I win again

Good man. Std cars are for.....

Revo it is. finally see how this car is ment to run. Itg full milltek and Revo stg 2 b setting (for now).

What do you guys reckon i should see bhp and NM wise. ??

Revo it is. finally see how this car is ment to run. Itg full milltek and Revo stg 2 b setting (for now).

What do you guys reckon i should see bhp and NM wise. ??

On a dyno dynamics you will see 215-220Hp with around 310Nm.

This was hurdys with full miltek TBE, ITG and water meth on REVO Setting B

Other rollers he had seen 235-2540Hp so its very dyno specific. ME personally i like to quote low and then it annoys biger power cars even more

Other rollers he had seen 235-2540Hp so its very dyno specific. ME personally i like to quote low and then it annoys biger power cars even more

Auric's company vehicle probably hadn't got that amount of power!

Auric's company vehicle probably hadn't got that amount of power!

what do you mean?

Auric's company vehicle probably hadn't got that amount of power!

Class 155 DMU, 285 bhp when new (each engine), now about 100 bhp I would think

Other rollers he had seen 235-2540Hp so its very dyno specific.

Damn. wish the rollers I used read 2540Hp! ultimate pub bragging rights.

As Sy said though, it's dependant on dyno but 220-225bhp should be the roundabout figure

That Duno is just what i was after. Was that dome at Revo??

If you are talking about the one Sy posted it looks like it was done at JKM

That Duno is just what i was after. Was that dome at Revo??

The dyno revo use is a bit higher reading from what I gather after seeing dynos of revo cars ran there as apose to revo cars ran elsewhere.

Class 155 DMU, 285 bhp when new (each engine), now about 100 bhp I would think

I'm lost!!

It's a train, he's a train driver. I think?

Sent from my Nexus S using Tapatalk

ah, gotcha. Was really lost there then

Revo it is. finally see how this car is ment to run. Itg full milltek and Revo stg 2 b setting (for now).

What do you guys reckon i should see bhp and NM wise. ??

Did you inquire at AMD in West Thurrock as they would do all this with a custom map. I'm not sure of the cost but when I was there they were fitting a Milltek exhaust system on an Audi A1 and giving it a stage 2 map as I was talking to the owner while I waited for my stage 1 map.

I only mentioned this as it's a lot closer.

Edited 10 April, 201214 yr by hammer32

AMD also have a golf in the British touring cars so they have a lot of experience.