Stiff connector for headlight bulb...

[justice]

Just wanted to double check I wasn't going to break anything- checked the manual and it says just to remove the connector first by pulling on it.

 

Should I use a screwdriver to help it on its way? Wanted to see if there was a certain knack to it or If i should just be more ruthless with it!

 

I'm not with my car at the moment otherwise I'd be trying it out!

[Prog]

Just be ruthless. They're a tight fit but will come off with brute force.

[justice]

Cheers, will attack at lunchtime!

[KenONeill]

They're tight to prevent arcing as they pass a 5A current to the filament.

 

The manual is correct too; pull the connector off before unlocking the bulb holder.

[chris c]

It's just possible to get a flat bladed screwdriver in there to prise it a bit, then it pulls off easily

[Hyphons]

Call "Stormchaser" I wasn't even man enough to remove them and had to go to his to get them removed when I changed the bulbs they loosen up over time, perhaps wear gloves to get a better grip but yes, yank the **** out of them and prepare to smack your knuckles when they finally come loose

[Stormchaser]

Haha yes they're very tight [emoji16]

Sent from my iPhone using Tapatalk

[Prog]

Did you manage it, justice?