Hey guys keep getting afs bend light warning. It only came on after I got car valet...here is a pic of the scan.. Anybody have the same issue before?

Self diagnosis can be done here using the fault codes from your scan...

 

http://wiki.ross-tech.com/wiki/index.php?title=Category:Fault_Codes&pagefrom=01273#mw-pages

 

Here is the first one (002233)...

 

http://wiki.ross-tech.com/wiki/index.php/02233

 

Did the valeting company use a high pressure jet wash to clean the engine bay? If so go back and slap each and every one of them in the face with a wet fish.

Cheers for that... No they didnt wash engine just outside and inside but not the bay

That's good then. I still suspect water ingress though. It is possible to soak the wires / loom with an unlucky angle through the grill.

 

Take a look down the back of each headlight for water or moisture.

 

The motors inside the headlight are well documented on here to corrode and seize but it does sound strange the issue only appeared immediately after a good soaking.

Are the motors inside tye headlight? How do access them... Some of them codes mention control unit?

See here...

 

http://www.briskoda.net/forums/topic/391608-no-bend-lighting-afs-function-fault/?fromsearch=1

Thanks

Can someone tell me where the afs control module is located?

Just checked codes both headlight not getting signal would this point to needed a new module??

If it's in the same location as the MkII Octavia...

 

http://www.briskoda.net/forums/topic/318836-octavia-afs-issue/

 

Are you sure it isn't the level sensor on the suspension, it shares a similar fault code to the AFS module...

 

http://www.briskoda.net/forums/topic/408744-afs-fault-lights-no-longer-adjusting/

 

Another water related issue here...

 

http://www.briskoda.net/forums/topic/286306-no-bend-lighting-afs-function/

Hi fella.. I'm still not sure both sensors look to be in good condition and attached with no damage or corrosion..

Just with the fault codes it shows that both headlights are not getting signal..

Lights are pointing straight ahead and not at floor or sides..

Took rear off lights today and used hairdryer just incase water got in and that didn't make any difference

Thanks again for all your help lad much appreciated by the way