I have read across the internet that the headlight washers can be coded with VCDS to have a slower response time from using the screen washer stalk. I looked in BCM for the adjustment Bytes and Bits - STG09, fct 07, Byte 5 - where I should be able to increase the number in 50 ms increments.... But that adjustment does not show up in my BCM.

Has anyone been able to ajust the response time on his / her Superb II?

I can set the jet interval, but that is quite a corse adjustment.

 

Also what happened to the coding / VCDS / VCP section on Briskoda?

VCDS section is still here:

https://www.briskoda.net/forums/forum/23-diagnostics-amp-vcds/

I found VCDS now. My PC was dead slow to load and I did not think there was much else loading.