No issues using Canbus error free lamps. I followed a link somewhere on this forum and got them from AliExpress a long time ago. Since then there has been a few other places to get then from, again mentioned on the forum. Certainly no need to do any coding as I don’t have any gear to do coding in any case.

Ha, just notice the topic below. Great write up and the AliExpress link.

Edited 2 February, 20206 yr by westie38

Jonro2009

how did you enable High Beam Assist

Thanks

Good evening everyone, sorry for the perhaps trivial question, but it would not be better to connect the negative to a land of the door that cut the wire and use the pond

 

Great DIY, thank you so much.
I will be using this guide to do the same on my Octavia MK4. I checked the diagrams and the connections are the same.

Hey Crapula, YOU ROCK!!! Thank you for this amazing post, so easy even a girly could do it, now I have my vRS Kodiaq Bear welcoming me home!!! I owe you a hug and a beer (or many) Thank you!!

Edited 18 December, 20241 yr by Putter

Hello @Crapula ,
First of all, congratulations for the very well explained how to. I have a Skoda Karoq 2019 and I already have the welcome and emergency lights from factory but now I am thinking to install the interior door handle light. I don't think it was ever an option for the Karoq but I think I can adapt something from the Skoda Superb/Octavia.
I already have the light module(basically it's an LED with a housing) and I found the coding in the door module(42 & 52) with VCDS (interior door handle light installed) but I don't know which are the pins that I can use from the door module, I mean I have found some Karoq manuals but I don't see the desired pins.
I was wondering, maybe you could help me with the pin numbers?
Thank you!