Skip to content

What kind of screws for brake dust shield? Workshop manual doesn't say - Please help 😅

Featured Replies

Hello,

I was hoping someone in here might know which kind of screws (no. 4 on the first picture, no. 9 on the second picture) for the dust shield i need? Considering it says replace after removal i would like to buy new screws.

And i think this is the right configuration, the PR code for my brakes are 1KD. Which should be C38 - 15" brakes, so i believe this is the correct setup (second picture).

Thank you in advance for any help! 🙏

image.png

image.png

  • Sponsor

https://www.lllparts.co.uk/catalogs

3 hours ago, Bifa said:

I was hoping someone in here might know which kind of screws (no. 4 on the first picture, no. 9 on the second picture) for the dust shield i need? Considering it says replace after removal i would like to buy new screws.

No idea except that dust shields are not compulsory, so you can remove them and nor replace.

  • Author

Oh my, that link transported me into wonderland. That is so useful. I found out that it was a M10x40 hexagon head bolt (https://www.lllparts.co.uk/product/WHT003853/hexagon-head-bolt-combi).

Thanks so much for the help Breezy-Pete 😁

And thanks for the tip Paws4Thot, but I think I will replace them, to avoid getting dirt into my brakes as much as possible 😊

Edited by Bifa
Used a swear word, woops.

5 hours ago, Bifa said:

And thanks for the tip Paws4Thot, but I think I will replace them, to avoid getting dirt into my brakes as much as possible 😊

Those screws aren’t just holding the dust shield on, they appear to be securing the axle stud. Even if you removed the dust shield, you would still need to replace the screws, or your rear wheel would fall off.

You don’t need 4-off M10 screws just for a dust shield. 😉

39 minutes ago, daveo138 said:

Those screws aren’t just holding the dust shield on, they appear to be securing the axle stud. Even if you removed the dust shield, you would still need to replace the screws, or your rear wheel would fall off.

You don’t need 4-off M10 screws just for a dust shield. 😉

I misread the exploded view; thanks. The point about not replacing the rust shields/stone catchers still applies though I think.

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Important Information

Welcome to BRISKODA. Please note the following important links Terms of Use. We have a comprehensive Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.