furbyPD100

There's quite alot more than bumper and wheels Mines an 51 elegance estate & ive got a Long list of what I've done to mine and mines far from a vrs estate Gfwc did a lot to his

Got mine set like a gentle bounce have heard in the long term hardcuts put strain on cam belts and turbos

I never lacqured mine lol I rubbed mine back and polished em over a year ago and there still crystal clear, just go over em every now and then with wax, actually had a few people ask me if I'd put new headlights init

I have a handheld VGate VS450 that the Mrs bought me does what it says on the tin, read codes but does not just give you a code it tells you what it is, also deletes codes resets service intervals aswell It's mainly for vag group cars but I have used it successfully on a few other cars as it has a few different protocols to connect

It's quite straight forward I put Leon cupra fronts in mine and you don't even had to take the cover off, just take all the plastic surrounds off and the covers just unclip with the foam attached, swap it to the fabia base and clip it all back on, And the back of the seat litterally just bolts on to the fabia base

£30 posted?

That eoi wow not seen one with an eoi that far past TDC, I thought I was pushing my pd100 at 10 degrees eoi, from the graph yours looks to be around 18 degrees

Passenger side lights, done mine a while back but I believe all lives needed can be found on the passenger side of the car

Scotch blocked mine in never had a problem done plenty like it before

Yup all of the fabia's ATD engine codes are fitties with factory single mass flywheels (G60)

Don't agree anything is an improvement over the factory smic as there useless, have you ever logged a mapped tdi on intake temps ? It's not good at all I run this tx autosport kit on mine and logged before and after it does it job perfectly halfed my I take temps and stays low aswell http://www.txautosport.co.uk/seat-ibiza-19-tdi-lower-front-mount-intercooler-kit-335-p.asp 65mm thick core

Tech1 Recently changed mine from the pd100 maf to the 130 and also spoke to a few people including fabooka and all have said not to worry about changing anything on the map unless your aiming for big power And to be honest been using the car for a couple of weeks with the 130 maff on only thing that has changed it that it seems to be letting my turbo spool up a little quicker as I'm getting a little more throttle responce when driving, wouldn't say it's got more power just a little more responsive

Have you put the PD130 3" maff airbox and flexipipe?

Yes aslong as everthing on the car is well, a custom map will see 145-150 if your looking for all out power, I have a pd100 estate is running a custom map but with a few other supporting mods and is around the 150 mark and it pulls very well and still returns good mpg A few upsides of pd100s is smaller lighter 5speed box, weighs less than a vrs, also if it's an early ATD engined car they run single mass g60 single mass flywheels from factory so nothing really to worry about clutch wise and the standard turbos are known to be quite strong

I'm heading towards cyclinder pressure, so the obvious would better/coated Piston Would not lowering compression have a similar effect ?? I know it's a little say.... Tricky as dervs work off compression but would it be worth a try but again it would be hard to test