Chickenlickin

All the brakes were done thanks

If that’s the case I normally have to have my service light turned off once a year I can get it done then. Thanks

According to my book it’s the front pads wear light orange

Hi a few weeks back the brake wear light came on, on the last mot it referred to brake discs rusty and pitted so I thought I’d change everything which was done by a mechanic mate. He said the brake wear sensor wire had been cut and jointed so not the fault, I have checked the joint and it’s good done all the other things mentioned on this site like fluid level, it’s the orange circular with part circular rings either side. Any help appreciated

Thanks a lot great help

I have fitted a Amundsen+ fitted in my 2007 Fabia 3 and want to update my Sat Nav can anyone recommend a genuine site thanks

Hi Breezy_Pete will sort you out 👍

Hi Pete just put it back in and it does not work, so I agree the exchange unit seems the way to go I’ll await your reply thanks

Hi I have a 2007 mk2 Skoda fabia 3 both my windows packed in strangely after changing my battery, checked door over and found at least 7 wires broken these were repaired and the windows worked while I still had the door panel loose, once it was refitted they did not work. Just had the panel off again to check the wires all ok (it’s now raining so had to stop) just wondering if this problem could be related to the repair you are advertising, I will put it back together once the rain stops if they do not work and you think the repair would fix not a problem sending it to you or having an exchange unit. Regards Daniel

Hi no idea of part no’s but the silicon sealant will do the job if you clean everything first and if I remember rightly on mine someone had pierced a hole in the grommet at the bottom of the wheel well, found one on eBay the right size. All still working fine hope it goes well cheers

I know this is an old forum but I’m trying to find the answer to the same problem 2007 Fabia3 mk2 service indicator will not go off tried all the possible remedies listed on the internet but it will not reset. Does this mean I have to pay Skoda to reset ?

You have to remove the bumper to take the old sensors out and drill the hole out from the rear, no relay required just snap connector too reversing light wire. the new sensors then just push fit into the drilled out holders.

Very easy the only problem if you can call it that was the old sensors clip out of the holder glued to the bumper, so once I’d removed the old sensors I used the hole cutter supplied with the new sensors to cut the hole in the front face of the glued holder to the correct size did it from the back kept it central by rapping tape around the cutter until it fitted the back part it kept itself central. Hope that helps. Regards

I know this is an old post but I have the same problem on my 2007 mk2 Fabia found out yesterday while fitting rear parking sensors, there was 2” of water in the boot, just wondering about the rear vent don’t remember seeing the cover above it ? did you just pour water over the rear when trying to find the leak.

Hi Keith that’s great as I ordered a set of those yesterday nice to know there ok thanks again.