I have done the factory reset and faffed about in maxidot but no way is Yeti showing the cruise speed in the display I did get my 4 flashes on the comfort wipers though 

OCT II FL , MY2010 , Diesel PD 140 , activated in 5seconds

So you are saying that you get the cruse signal on maxidot, like the golf

Exactly Alberg. I made the conding quick , i doesnt have to start the car , i just switch in the garage cruise control to ,,on,, and the KM changes to small ,,gauge,,... And i think i have the latest softwares in my car (which are available in Slovakia). I bought the car last week (used) and i have immediately visited ofic. Skoda Service Center. Checking, updating... After that , i made all the setups via VCDS in my garage (im an ex ofic. VW CAR CENTER seller)

Need the de coding for this.

As i can activate the cruise display but it doesn't display

Should i something check for you in my coding/options ?

Thats the thing, like myself many here can activate ir using vcds/vagcom but nothing happens

Maybe we can compare some controller part numbers , coding , and at least find the answer ,,why ?,, it doesnt work , or what you need to replace to make it work.

Can you take a picture of the maxidot for us to see

of course alberg. i make pictures for you tomorrow. only from maxidot ?

http://youtu.be/4Aft4p1iumg

Edited 22 July, 201411 yr by puntoii

Very nice, how did you code it to try it your way

I'am just activating the HIGH CRUISE CONTROL in 17 - Instruments Cluster. That's all 

So I've tried to activate this but doesn't seem to work.

 

I have a 2011 FL 1.4 (CAXA) with Maxidot and DSG.

 

Anything else I can try or it's just not going to work?

It works on my 2008 pre-facelift vRS with FL Maxidot.

 

(Don't know if this is useful...):

Engine
Part #: 03L906022GB
Coding: 72 (decimal)

Instrument cluster
Part #: 1Z0920943M
Coding: 710A01 (hex)

Central electronics
Part #: 3C8937049E
Coding: A5880F230004140F43110D000000000080197F073200000C000000000000 (hex)

Body/convenience system
Part #: 1K0959433BT
Coding: 98801A085283007F3F048D0D4008DF96907CA0 (hex)

CAN network gateway
Part #: 1K0907530Q
Coding: E9807F060002022303 (hex)

 

Edit: I didn't enable it myself.  I don't know exactly what my VCDS friend did.  I seem to remember it took a few ignition cycles but it stuck thereafter.

Caveat:  I can't see the images at the start of the thread.  I'm just assuming you're on about the graphic in the bottom left of the display when cruise is set.
 

Edited 25 June, 20205 yr by mrhappy
extra info

Tried this on my 2010 diesel and it didn't work

this is all dependent on the ecu software