Morning guys a quick update from the weekend, We have had a rather clean Fabia visit us. (recommendation from a forum member, Thank you)

 

This VRS is far from stock and was running a stage 1 map from a well know tuner, the dyno results show 157 BHP. The car is using the PD150 turbo with the Airtec intercooler.

 

Please see our BLOG post for more on the specs and the results - http://www.sntuning.com/skoda-fabia-1-9-tdi-remap/

 

Please see the picture below showing the initial read of the software by our very own ADAM.

 

157bhp on a PD150?

Sounds like it was mapped before the turbo was fitted.

Considering a generic off the shelf map on a PD130 will give 170+ all day long.

absolutely correct, the biggest issue was that the smoke and torque maps were "set" lower that the actual request that was made. This is why we worked with an original file for peace of mind know we would not come against similar issues.

 

Currently we are running 1.6 BAR (peak) with 70 MG of fuel we are not encountering any real smoke.

 

Kind Regards Matt @ Super Nova Tuning

Should bring it along to Combe action day or the Fabia mk1 Santa Pod meet

1.6 bar should see 190bhp or there abouts.

I'm running 1.9 bar and achieved 224bhp.

As a new sponsor though welcome to the site. I look forward to seeing what you can do

1.6 bar should see 190bhp or there abouts.

I'm running 1.9 bar and achieved 224bhp.

As a new sponsor though welcome to the site. I look forward to seeing what you can do

 

Good Morning, The power depends upon the many other factors other than boost, this particular vehicle has 3" pipework with the AIRTEC cooler so the temperature drop is considerable over the factory unit therefore thermal efficacy is greater meaning less waste and more power from the same or lower boost.

 

We have yet to run this on the dyno results are loosely based on the GPS runs we did at the time, next week the client is returning for his dyno runs.

 

Kind Regards Matt @ Super Nova Tuning