Jump to content

a/c not working still after being re gassed


Recommended Posts

Educated guess I'd look at the a/c compressor. I havnt came across a vag car of that age yet that either doesn't need one or has already had one. My mk2 vrs had had one just before i bought it, that was 69k 07 plate. My mates 08 Mk5 Golf gt was blowing warm air traced to compressor and my current car Seat Leon fr 07 plate 53k needed a new one last year!!

Link to comment
Share on other sites

Mine ended up being the High Pressure Sensor recently. I had intermittent AC working. I noticed on VCDS it was flagging this as a fault but also low pressure of the refrigerant.

 

2 Faults Found:
 
00819 - High Pressure Sensor (G65) 
            009 - Open or Short to Ground - Intermittent
00229 - Refrigerant Pressure 
            002 - Lower Limit Exceeded - Intermittent

 

Checking the measuring blocks showed the bar pressure value being all over the shop so it was certainly the sensor. 

 

The old sensor from my 06 plate needed a gas change (full vacuum and new gas and oil) since as soon as it was loosened some gas would escape. A pig of a job apparently but was done from under the car just by removing the under tray.

No bumper to come off or anything.

 

This part has been replaced with a newer type sensor to allow swap out without loosing pressure.

Link to comment
Share on other sites

Reset fan's. Hold ac and front vent button in until green lights start to flash. You will hear vents moving around. This cured mine as I got a regas and still wasn't cold.

Done this the other week after suffering for months now cold as ice.

Link to comment
Share on other sites

Just to let u know, I took my car to a AC specialist today and it was diagnosed with a faulty high pressure switch, causing the gas to leak out, thank you again for the advice guys

Link to comment
Share on other sites

Just to let u know, I took my car to a AC specialist today and it was diagnosed with a faulty high pressure switch, causing the gas to leak out, thank you again for the advice guys

Glad it's sorted out but it may be helpful for others in future if you post any part numbers if you have them. Also how much did it cost to get it fixed?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Community Partner

×
×
  • Create New...

Important Information

Welcome to BRISKODA. Please note the following important links Terms of Use. We have a comprehensive Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.