I drove my front right (driver side) wheel through part of a puddle and after that my car made a high pitched noise and came up with error codes. 

 

Once I switch my car on the following comes up

Stabilisation control (sec(

The Park pilot is currently not available

Tyre pressure loss indicator 

 

I can then put the park pilot and speed setter on

 

Once I set off the ABS Error and ACC front and rear assist error shows up

 

 

Can someone please help 

 

Sounds like the ABS sensor has problems

I will check that out and give it a clean

4 minutes ago, ketiljo said:

Sounds like the ABS sensor has problems

Had a similar thing happen when driving through a puddle leaving the Covid vaccination centre in Barnstaple, the right rear ABS sensor had failed - and as it is integrated into the rear wheel bearing meant we needed a new wheel bearing at a cost of over £500 (hope the front ABS sensor is a stand-alone item!).

1 hour ago, PetrolDave said:

Had a similar thing happen when driving through a puddle leaving the Covid vaccination centre in Barnstaple, the right rear ABS sensor had failed - and as it is integrated into the rear wheel bearing meant we needed a new wheel bearing at a cost of over £500 (hope the front ABS sensor is a stand-alone item!).

The ABS sensor integrated into the wheel bearing? Not the case with my car 2013 1.4TSI Elegance

https://www.autodoc.co.uk/car-parts/abs-sensor-10138/skoda/octavia/octavia-5e3/126002-2-0-tsi-rs?criteria[100][0]=HA

Could be water has got into the ABS connector.

3 hours ago, Vahids said:

The ABS sensor integrated into the wheel bearing? Not the case with my car 2013 1.4TSI Elegance

https://www.autodoc.co.uk/car-parts/abs-sensor-10138/skoda/octavia/octavia-5e3/126002-2-0-tsi-rs?criteria[100][0]=HA

Bad wording on my part - the sensor is separate but the ring that is sensed is integral with the bearing.