DISCLAIMER:-You follow this at your own risk, I am not responsible for your errors!!

OK, so all the Blackline owners out there who want to enable Bluetooth and install the microphone here’s how to do it.

1. Enable the BT using VCDS, here’s the link how to do it:-
   

http://www.remkoweij...uetooth-carkit/

1. Order the microphone from Carsystems
   

http://www.carsystem...only,id387.html

or Eddie-NL:-

http://www.briskoda.net/forums/topic/274292-blackline-bluetooth-kit-loom-mic/#entry3244289

1. Ensure that ignition key is removed
   
2. Start to remove head unit surround using trim tool.
   

1. Remove the four T20 screws from the head unit
   

1. Pull the head unit forward carefully and remove the quadlock using the latch and remove the aerials, there is a clear tag that pulls forward and is pressed down to release the three leads.
   

1. Remove the passenger side panel using a trim tool (same setup as fuse cover).
   

1. Remove the five T20 screws from the glove box, remove the aircon pipe and light connector.
   

1. Remove the A pillar cover using a trim tool, quite easy to pull off.
   

1. Remove the interior light by removing the lense with a trim tool and remove the two Phillips screws (one either side of the main light bulb). Remove the foam insert and insert the microphone (should not be connected to the loom at this point). The mic is keyed.
   

1. Insert the green connector until the barb secures it.
   

1. Run the loom (up to you how you do this) behind the glove box and up the A pillar (lots of option how to do this). You need to get the connector all the way to the hole where the interior light was (the loom can be easily squeezed into the roof ling and out the hole).
   

1. Connect the loom and mic together and clip the connector into place (I used a bit of the fabric cloth tape I took off the loom to insulate the connector as a bit of screening was exposed)
   

1. Refit everything back in reverse and there you go one BT mic installation.
   

Well done, can i book an appointment ? You could make a few bob doing this eh????

s

Just ordered the mic kit...

Edited 12 October, 201213 yr by sly200sx

Hi sorry for sounding daft but why are you fitting a mic? douse the Blackline not have hands free enabled? the dealer told me it was included. :wonder:

Hi sorry for sounding daft but why are you fitting a mic? douse the Blackline not have hands free enabled? the dealer told me it was included. :wonder:

Your dealer is wrong.

Your dealer is wrong.

+1

Well done, can i book an appointment ? You could make a few bob doing this eh????

s

Just ordered the mic kit...

Once the BT is enabled it's a simple job, I don't have the time.

Hope this helps everyone who has been mislead.

Great guide - thank you for taking the time to photograph it properly!

I look forward to the look on my girlfriend's face as I dismantle the first brand new car we have ever owned

oooo well id better get a mic on order then. who can update VCDS do i need to go to the dealer or can a back street garage do it?

Awesome guide - I've just informed the wife of the first "mod" that I've got planned as soon the car finally arrives, I'll not describe the look that she's given me!

someone on the 'when does my blackline arrive?' thread said they had a company near Southampton who could enable the BT via the VCDS for a very reasonable 30 quid - if I can find the link I will post it up...

Anyone know any other companies in the south who could do this?

Physical connection aside.........will this mic work with any car-kit? say a Nokia?

(tidies the insides of the car up a little)

or the north east

or the north east

Where you getting yours from, Silbury in Cramlington have promiised to enable it during the PDI (free) . Picking it up tomorrow so hope its done.

excellent guide there fella! I just need to find someone in northwest who can help me!

Where you getting yours from, Silbury in Cramlington have promiised to enable it during the PDI (free) . Picking it up tomorrow so hope its done.

On another thread it has been said that the dealer software couldn't do it.

Its a long story but im getting it trough a Mitsubishi dealer in Darlington but the car is being supplied by the main dealer next door to them.

Anyone know whether the VCDS lite software (available for free download) is capable of accessing the BT checkbox?

The Ross-Tech function table says that it can access the 07 function that allows changes in the code modules; is this where you make the changes?

If so I might try it out myself with the right cable...

http://www.ross-tech.com/vag-com/vag-functions.html

here is a company nr Brum who could do it I reckon:

http://www.vwrescue.co.uk/vw-diagnostics

You can find companies to try here:

http://www.whocanfixmycar.com/Services/Skoda/Diagnostics

If anyone has any luck please post the results and prices?

Why not ask fellow briskodians? There are plenty about and most won't want anything more than beer to code it for you

Oh and a week after owning a brand new car I had the front bumper in the living room. Old man kept pulling faces when I took it off!

Why not ask fellow briskodians? There are plenty about and most won't want anything more than beer to code it for you

Oh and a week after owning a brand new car I had the front bumper in the living room. Old man kept pulling faces when I took it off!

If I was spending £xxx pounds with a dealer I'd expect it doing for free

On another thread it has been said that the dealer software couldn't do it.

More Like they don't know how to do it

Our dealer system doesn't use check boxes like VCDS. If there isn't a test plan or function written for it we can't do it.

I have full VCDS and skills to fit if anyone local wants it done.

Our dealer system doesn't use check boxes like VCDS. If there isn't a test plan or function written for it we can't do it.

I have full VCDS and skills to fit if anyone local wants it done.

Where abouts are you bud?

More Like they don't know how to do it

Our dealer system doesn't use check boxes like VCDS. If there isn't a test plan or function written for it we can't do it.

I have full VCDS and skills to fit if anyone local wants it done.

Wasn't aimed at you personnaly Tech1e, was meaning more the Sales Department don't know what you can/cannot activate on the car or what the car actually comes with as standard