Hi Everyone!

 

I have an Octavia II and I am trying to change my Audience radio for an Aftermaket Radio. The problem is after I connect everything there is no Sound...

 

I contacted the seller and he said that I need to connect the AMP cable on the radio to the DSP EIN cable on the Skoda.

 

The problem is that I don't have any ideia where the DSP Ein cable in the skoda is.

 

Can anyone help me with this??

 

Thanks in advance!!

 

Rui

what is the make / model of the aftermarket radio? 

 

It’s this one 

 

https://rover.ebay.com/rover/0/e11051.m43.l1123/7?euid=5075a5333d4d415fa28412aa024e4dcf&bu=44528857652&loc=http%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F182753818947&sojTags=bu=bu

Sorry... should also have asked what model your car is! 

Exact model

Year, original speaker / amp setup etc.

 

I am guessing it's one with the amp mounted under the passenger seat in which case you may have to run your own speaker wires from there to the head unit as i have a sneaky suspicion that you need a canbus signal to control the amp

 

This pinout may help you...

 

https://workshop-manuals.com/skoda/octavia-mk2/vehicle_electrics/electrical_system/infotainment/sound_system/contact_assignment_at_the_amplifier_up_to_my_08/

Thanks!!

 

Is that for a skoda Octavia II?

From what I understand, all the communication (on/off/DSP settings) are all done via CAN-bus on a MK2 so there isn't a "remote on" pin.

 

You might need to ask what the seller means by a DSP EIN cable is as it's not a term I've come across in relation to the MK2.