UrbanPanzer

this is why its important to post your car details............if you dont specfiy then this is what happens. No they are both hatch backs............

where have you tried...... took 30 secs on Ebay... https://www.ebay.co.uk/itm/2013-SKODA-FABIA-MONTE-CARLO-HATCH-WHEEL-BOLT-BREAKING/324348834260?hash=item4b84b271d4:g:mgoAAOSwvk1flsC4 another https://www.ebay.co.uk/itm/SKODA-FABIA-MONTE-CARLO-1-2-tsi-CBZB-ENGINE-LMG-GEARBOX-LF91-FOR-BREAKING/392970160131?hash=item5b7ed8c803:g:MxYAAOSwgbpffIhr

No Need to pay for anything really, this is pretty straightforward to do.........these would be simple to wire up for main beam use only. Below is a simple wiring diagram and the yellow "high beam wire" would be the wire which feeds the shutters on the headlamps for main beam. I have also attached wiring for the car Left hand Headlamp..........you would need to confirm by checking your vehicle, but PIN 8 of the headlamp 10 Pin connector should be a white wire which is + 12v live with main beam selected ON, if that is the case, then tap into this and it need to be connected to PIN 86 of the relay as in diagram below.

A Golf !!

There are so many variants, you really need to post your engine / spec of the vehicle as well........ Anyway, also check Fuse 17 and 18 + make sure you are 100% that you have read the fuse diagram and checked correct fuses to date, it is VERY easy to miss-read...

me 3 !!! Out of interest , did you never contact them about it ? it looks to have the correct profile to fit...........

workshop removal........

piccy to small buddy...

Ah ok, any piccies ? Have been tempted by one of these grilles, but if its not a perfect fit it will really annoy me !!

Is this noted from yourself as you have one fitted ? if so any piccies ?

did you translate it ????? .....................or select English from the menu, that way the shopping should be self explanitory as with any other web order....

So have we replaced / checked / changed the bulb in the O/S headlamp ?

don't understand your question......................

Cannot offer specifc advice on the oil filter, not sure what the issue is with that vehicle / engine......................... but I will say EVERYTIME the filter is removed, NEW seals should be fitted. Cabin filter takes 20 secs........actually did mine yesterday, did not think of a guide but will do next time. Slide passenger seat fully back, then with torch remove "trim" above passenger feet (if fitted, just pulls out) then you will see the square end of the filter box..... slide 2 clips towards each other about 1/4 of the length of the housing, then the cover will come down / off. Pull filter out noting direction fitted, fit new filter fit cover and slide locks back into place refit foot well trim.

Don't IMO................often they are to bright.

Thats why I asked, this is the Fabia forum and none of them sizes matched up.

The "best" solution would be to replace panels, should not be to expensive via ebay I would think....................OR measure the diameter lower pegs (image below) as they are the same for when the shelf is fitted lower down, then maybe you could purchase a metal pipe (like heating pipe) or similar and fit it all the way across between both panels, cheap fix but would work.

What car is this for ?

Shame you don't realise just as quick to have a sense of humour.

What was it you said to me.............. Are your eyes ok?

You have to remove the centre console, then using 2 small screw drivers you release the switch tabs from underneath, you will see this once the console is out.

Exactly why I never bought a 3 cyl........to lumpy.

I have used flo-flex on many Land Rovers with no complaints.