pab567

PM

Model number and current SW version of your unit?

Can you link a movie?

There can be few reasons, mostly it is full NAND that must be erased and programmed from scratch, or faulty MPEG module.

Check your PMs

Search briskoda for update manual and just follow it.

PM

PM

All check your PMs

Pls pos Pls post picture with part number and SW version

You can downgrade from Service Menu / Testomode /. Manual SWDL but you must enable Developer Mode in adaptations first.

Rather restore default settings in your infotainment system

Check your PMs

VIN?

You are either missing two-wire cable for left channel audio streaming (which should NOT be the case in 2014 car) or this cable is broken or the left channel input in your radio is broken.

This thread is for MIB2 / MIB2.5 HIGH units, pls post it in the thread for Amundsen SW update.

It's not the question of connectors, it's a question if your unit supports it... unit modle number?

You can make the update while driving or with engine running.

Then I believe everything is OK and you should not expect any issues.

One more check - entern each of them and check if VIN indicated there is equal with the one of your car. if yes then 99% your cods are official and you can proceed.

When unit is connected to the Internet updates are automatically downloaded and installed.

Either OTA (Over The Air) or contact your Skoda dealer.

Go to Service Menu (long press MENU button) then FEC/SWaP codes then Installed Codes. Paste the list of codes and your VIN here. Check if every code has your VIN inside.

I don't have any firmware for your unit 😞

If these are official codes - no. The risk is only for hacked units with non-officially installed codes.