westie38

***REDUCED***. For Sale - Set of four Skoda Sirius 7J 19" Alloy wheels and excellent Nokian WR A4 225/45/R19 winter tyres. Wheels and tyres bought brand new and only fitted between November and the following April each season. Wheels totally cleaned and protected inside and out when taken off, then bagged up and stored. Used for just 15k miles over four years. £425 ovno, buyer to collect, East Yorkshire area.

This might be better: Read down to my bit as it's not really necessary to take the door trim apart. The link to the parts are at the top of the thread.

Have a read through this thread in the Karoq section: INSTALLATION OF THE WELCOME AND EMERGENCY LIGHTS (RED) OF THE FRONT DOORS. Really easy mod to do

Yes, 14 x 1.5 is the correct size for your Karoq. I bought one of these from eBay a few years back - absolutely brilliant bit of kit. Makes changing wheels a doddle, as I swap summer/winter wheels annually. Mine was from TRS UK, but they're all of a muchness.

Just curious if any Karoq/Kodiaq owners out there has had any problems with the rear fog light not working? I haven't had the need to use the rear fog light for ages but when I did try it a couple of days ago it was very dim (they have 3 LED's) and flickering. After a few seconds a fault light comes on the matrix, together with the message "Please check right rear fog light" (even though it only has the one). The fault light and message does not latch, and disappears after switching off the engine and doing a restart. I've bought a replacement fog light from Skoda and intend to replace it asap as there is a very good video on YT regarding taking off the rear bumper. The only dodgy bit is doing it in the very cold weather as, after removing the two light clusters and lifting the plastic clips which retain the top of the bumper. Probably a job for a hot air gun to warm thing up a bit. Thanks.

My tuppence worth too? Unless the AdBlue system was calling for refilling, to my mind it should have been left alone. I usually let mine get down to about 200 miles to go, then refill from a 10 ltr container. It normally takes about 9 ltrs, and then I put the remaining 1 ltr in a couple of months later. It sounds to me like they have either grossly overfilled the tank or not followed the correct refill procedure. For a salesman (who could have been selling shoes a month ago, or could be selling carpets next year), to say it 'should' disappear in a day or so, and it was not unusual is complete twaddle. If the proper procedure was followed ie refill until the first cut off glug (for want of a better word), then switch on the ignition only for around 30 seconds (no engine start) so the the AdBlue system recognises the quantity. After that, you can start the engine and all should be well. The status of the AdBlue can be seen in either the infotainment screen or the MySKODA app if you have it - from about 1k miles it will display the remaining milage, other wise it will show FULL. It's a pity your first venture into Skoda ownership has been spoilt by poor customer service because they really are good cars and represent excellent value for money imho

Cheers Kenny.

Out of curiosity, is the Haldex gauze filter a replaceable part ie clipped in, or does it form a fixed part of the Haldex unit?

My Karoq has always done this, temp up or down. I don't know the significance of it is, but it doesn't seem to have any detrimental effect on it.

Yes, fortunately it was still under warranty, so I took it back to the dealer and got one of their tech guys to have a look at it. The BLIS indicators flashed very briefly as described above, and I believe they simply re-flashed the software and it all was well. Touch wood, it has never gone wrong since, which is just as well, as without it being in warranty I would reckon they would tell you there was all sorts of catastrophes, not to mention costing nearly £100 just to hook it up to the diagnostics. The whole process was done in the time it took to have a coffee there.

Mine did exactly the same thing a few months ago. The passenger side mirror sometimes did not move at all, other times it would dip down but then return to its original position. The drivers side mirror had no control at all for a while. tried everything you've done, but in the end I reset the whole seat memory position, then reset the dip on reverse passenger side mirror. So far so good, everything seems to be working fine for well over a month.

As Root says, it's a PITA if you're stuck behind a car with its brake lights on, as is being behind a car which has its indicators flashing away at an obvious left hand turn. In situations such as being stopped at traffic lights I make a point of waiting until the next car coming up behind has fully stopped (and maybe the next car along, if the traffic is racking up) then flicking the parking brake on. The dashboard brake light indicator changes after a few seconds after doing this so you know your brake lights have gone out.

Hi Warrior193, yes you may be correct about that but it should be fine for the time left before a coolant change when the water pump is replaced next December. Not sure about other VAG vehicles, but when I asked the Skoda parts guy he told me that they no longer sell the tank with the silica bag inside. Not sure if that's 100% correct or not but hey ho.

Hi, after reading various horror stories about the silica bags splitting inside the coolant expansion tanks, and having a slight loss of cabin heat inside my Karoq, I decided to replace the tank, rather than trying to remove the bag and risk splitting it in the process. It's a really easy job to do and not really expensive - £33.29 for the tank, £7.44 for 1 litre of coolant. After replacing the tank I then removed the silica bag from the original tank, but fortunately it was still intact. It's made from fairly tough plastic/nylon , folded over and heat sealed along three sides, so you'd be quite unfortunate for it to split, although many VAG owners have had this happen. What was apparent was the amount of crud in the bag and in the bottom of the tank. VAG must be aware of the silica bag splitting possibilities as, as far I'm aware, they do not produce the tank with the bag fitted any longer. As the cam belt & water pump will be replaced at the next service (5 yrs) I'm not concerned about the coolant needing any other additions to mix. Even though it has not cured the heating problem, at least it's a relief that there isn't a bag full of silica balls swimming around the coolant system and heater matrix.

I've been running Nokian WR A4 225/45/R19's for four winters now. As per others thoughts, they have performed far better than the original Bridgestones. Not that we've have any significant snow here, they are much more sure footed in cold wet conditions and with frost/ice on the roads. Far quieter than the Bridgestones as well, I run these in conjunction with Dunlop Sport Max RT XL 19's, usually between November & the end of April.

So, after doing a decent run to the Lake District and back, I have downloaded another VHC on my Karoq, and sure enough it is now showing no faults. Yet another glitch. Far too much technical witchcraft going on in modern cars.

Hi Tom, yes that was my first thought. It appears to be at the Max level at the moment. I'm trying to get another health report from the app but until I drive a decent distance the report is still dated 23 March. Hopefully it might have cleared next time around. All the lights appear to be working ok. Thanks.

Driving to work this morning and I had a yellow warning symbol come up on the central screen. If there was any message shown, i didn't get chance to see it, but after running the Vehicle Health Report on the My Skoda app, it came up with the following defect: Lights! vhr.warning.msg.39.4 The lights appear to be working ok, front and back. Has anyone any idea what this could be? It could be just a glitch, but coincidently the car is starting to have a few wobblers lately, insomuch that the left side mirror randomly fails to lower when reverse gear is selected, and in the last two days the cabin heating system is only giving out lukewarm air whatever temperature is selected. Maybe time for a full software reboot/refresh?

This is the method I use to update with the latest map versions: Download the latest map files Reformat SD card Open - Disk Utility Erase - MS FAT32 - this clears the SD card Close it all down. Extract downloaded files Copy all (3) metainfo, Mib1, Mib2 to SD drive When done, open and run CleanMy Drive2 (probably similar to blueharvest (above) ) This cleans the SD drive of any unwanted MAC files This should then load up ok onto the Columbus unit. Hope this helps.

I've recently replaced all four Bridgestones (September) at 32900 miles - all four had cracks showing along the edges near to the blocks. Glad to be rid of them to be honest, worst OEM tyres I've come across. Replaced with Dunlop Sport Max, which have been much quieter, although they themselves have now been put in to hibernation in favour of my Winter tyres (Nokian WR A4)

And another one, just found exactly the same thing on both sides of the car on the rear quarter light window surrounds. I used Gorilla Glue clear which doesn’t foam up, then a light spray of water to activate the glue. Followed this by running a length of masking tape along the chrome trim and inside the rear door frame onto the roof lining. By closing the door on the tape it pulls the glued trim tight against the frame. Removed the tape after a few hours, so far so good.

Hi, I have recently updated the new maps on 7 August. The latest version (as far as I'm aware) is HIGH12_P192_EU_202125 Hope this helps.

I don't have a Samsung mobile, but if it's any help my wife's Iphone 8+ fits in, even with an Otterbox cover (I've still got a paupers Iphone 7) The 8+ is 78 x 157 without the cover. Hope this helps a bit.

And, complementary damaged rear parking sensor.

4th Option is leak in to drivers footwell from joint between inner wing and bulkhead. Skoda Colander- Simply Soaking!