Cairus

The Side Assist is installed at the same time

So, here's the thing: The facelift bumper section is getting a fresh coat of paint. I picked up the last parts for the conversion today.

With the OBD 11 dongle, I've often had it light up but no connection. I pushed the dongle firmly once and noticed that it was stuck.

The TSR can be unlocked in every MIB 3. You can also basically remove your 2Q0 camera and install a 3Q0. The SwaP Protection is on the unit A5 not on the MIB3

I don't understand what this has to do with the TSR activation in the 2Q0 camera?

Which dongle? OBD eleven?

Activate byte 47 - Bit 6 Activate byte 51 - Bit 1 No warrenty

Connect OBDeleven to the vehicle. Control unit 03>Basic settings>Reset tire pressure monitoring indicator warnings

T16C Connector Number C Have 16 Pin's

Why mib?

How many black Connection you have bei the unit?

I have the Files etc. etc.

You have a 98% chance of a broken wire in the left steering column switch. The yellow and green wires are probably broken. Check that.

There's now a modified firmware, a SwaP/FeC generator, that allows you to hack the control unit. However, you should never go online to the control unit with a factory diagnostic device.

Yes, but 2Q0 is SwaP Protection

You have 2Q Kamera HW?

Remove Airbag Then you Take Out the Button

No the black connector Coding Byte 1 Bit 0 Set Activ

Unit 42 Connector T16C Pin 1 (12V +) Ground (0V -) T16C Pin 3

In 2008, there was a pre facelift on the outside, but an interior facelift. You can do whatever you want.

Pre Facelift have other BCM. The Output of BCM use PWM

No, the multifunction steering wheel climate display and PDC display no longer work because a different CAN protocol is used in the facelift.

The next parts have arrived... connectors and pins for wiring, the set of taillights is complete...

I'm sorry, but you haven't understood the system... I don't have any 0-100% instructions

Look Here leuchtenkonfiguration-erkl-rt-tbax-vag-codierungen.pdf