Looking to lower my octy III combi vRS 4x4 and hoping someone can point me in the best direction for which lowering springs I should go for. Seen lots of chatter about the pros and cons of H&R vs. Eibach; and input and advice would be much appreciated, as would any links 👍🏻. Same applies for wheel spacers; hoping to run 15mm all round but again open to advice/recommendations/links. Thanks in advance! 

I would go with H&R every time mate.. have used them on several cars including the octavia and now the superb and they are a nice compromise between comfort and practicality and handling. Have had mine fully loaded several times in the uk and Europe and it’s been spot on 

Yes as above, I'd say H&R is the most popular option we sell.

 

Damian @ DPM Performance 

When I specced 4x4 VRS, one of the differences the 4x4 made was that the normal lowered VRS suspension from Skoda could not be fitted and the ride height is the normal one. I was told this was to do with the Haldex diff. The ride height suits me due to the roads I use but I’m curious why Skoda couldn’t lower the suspension when after market kits can. 

21 hours ago, Esseesse200 said:

I would go with H&R every time mate.. have used them on several cars including the octavia and now the superb and they are a nice compromise between comfort and practicality and handling. Have had mine fully loaded several times in the uk and Europe and it’s been spot on 

Thanks mate 👍🏻. That’s good to know; I want her sitting lower but still want to be able to load her up fully without any issue

2 hours ago, MediumDave said:

When I specced 4x4 VRS, one of the differences the 4x4 made was that the normal lowered VRS suspension from Skoda could not be fitted and the ride height is the normal one. I was told this was to do with the Haldex diff. The ride height suits me due to the roads I use but I’m curious why Skoda couldn’t lower the suspension when after market kits can. 

I wasn’t aware of that to be honest pal. So to confirm: Skoda don’t lower the 4x4, but I wouldn’t have any issues fitting aftermarket lowering springs? How strange 

34 minutes ago, SaltyDave said:

I wasn’t aware of that to be honest pal. So to confirm: Skoda don’t lower the 4x4, but I wouldn’t have any issues fitting aftermarket lowering springs? How strange 

Some loaded and unloaded. Of the octy and now the superb... all on H&R 40mm

1 minute ago, Esseesse200 said:

 

Are you running spacers there?

1 minute ago, theandywaite said:

 

Are you running spacers there?

Yea 12mm all round mate 

24 minutes ago, Esseesse200 said:

Some loaded and unloaded. Of the octy and now the superb... all on H&R 40mm

The superb looks horny as **** with the tints done and roof box on mate 😍👌🏻

I’m thinking of 15mm spacers all round trip my octy. I think that and a set of 40mm H&Rs (following the advice) will enhance her stance perfectly 

5 minutes ago, SaltyDave said:

The superb looks horny as **** with the tints done and roof box on mate 😍👌🏻

Hahaha sexy innit. Bit of roof box p0rn lol. Cheers mate 

2 minutes ago, SaltyDave said:

I’m thinking of 15mm spacers all round trip my octy. I think that and a set of 40mm H&Rs (following the advice) will enhance her stance perfectly 

Yep 15 all round works well mate and you’ll not regret the H&R’s. If it’s a facelift model I think the rear was wider than pre fl so you might find 10mm on rear will do it 

She’s pre facelift mate so I’ll go with 15s all round. Heard of people with 20mm at the rear but not sure it really needs that much personally 

Spot on mate. I put 20’s on and it just didn’t feel right. 
I run 12mm on the superb with 19’s now but they are a 46 offset and the Octy is 51. So I run the old octavia pictoris 18” wheels with winters on and 15mm spacers. Still looks right too 

Mine with 20mm on. Rear and I think 15mm on front. Just didn’t seem to handle as sharp 

On 20/08/2020 at 20:53, Esseesse200 said:

Some loaded and unloaded. Of the octy and now the superb... all on H&R 40mm

 

Hi Esseesse200,

 

Sorry to dig up an old thread here guys, but I just wanted to confirm you said you were running 12mm spacers front & rear in these pics - So when you have the 19inch Xtreme alloys on the Octavia, they can be up in the arches like that when fully loaded without the tyres rubbing at all? That gives me great peace of mind if that's the case as that's what I plan to do 

11 hours ago, simonds3135 said:

 

Hi Esseesse200,

 

Sorry to dig up an old thread here guys, but I just wanted to confirm you said you were running 12mm spacers front & rear in these pics - So when you have the 19inch Xtreme alloys on the Octavia, they can be up in the arches like that when fully loaded without the tyres rubbing at all? That gives me great peace of mind if that's the case as that's what I plan to do 

Yes mate that’s absolutely spot on.. H&R springs and 12mm H&R spacers. That’s on a pre facelift car as the facelift ones have a wider rear track 👍🏻

14 minutes ago, Esseesse200 said:

Yes mate that’s absolutely spot on.. H&R springs and 12mm H&R spacers. That’s on a pre facelift car as the facelift ones have a wider rear track 👍🏻

 

Amazing, that's so good to know, thank you!  Mine is a 2016 pre-facelift so the same as yours. Just out of curiosity - I've heard a lot of people mention the wider rear track on a facelift car, but they never seem to mention a change in the front track? So does that mean the facelifted car has the same track width front & rear? Or is there still a difference between the two?