1 hour ago, ile7 said:

Easly done with carscanner, didn't had to choose other dataset version, just changed interior button option to allow open and close while ignition on and off. Closing with button pressed, opening tap button

Glad it worked ok. I’ve seen it work fine for some and others it won’t even read the module. I think it’s very dependent on what hardware you’re starting with!

On 01/08/2021 at 06:12, AlVal said:

Select the right module for the bootlid controller (6d), on the list on the right it's 'data transfer', and send the parent xml file (the one called "arbeits"), it will send any children files also

Hi, do you open the file and just use arbeits file? Thanks in advance Al

On 01/08/2021 at 06:12, AlVal said:

Select the right module for the bootlid controller (6d), on the list on the right it's 'data transfer', and send the parent xml file (the one called "arbeits"), it will send any children files also

Hi @AlVal do you just send the parent file not the whole downloaded file?

Hi. I have a problem configuring the trunk lid closing function using the button located next to the DSG shifter. My control module is 5Q0959107L. During the attempt, the error shown in the attachment appears. “Odśwież” means “refresh.”

2 hours ago, Dawid93 said:

Hi. I have a problem configuring the trunk lid closing function using the button located next to the DSG shifter. My control module is 5Q0959107L. During the attempt, the error shown in the attachment appears. “Odśwież” means “refresh.”

Facelift model?

5 minutes ago, defsix said:

Facelift model?

No, 2016.

It seems very hit and miss as to if it works with carscanner. Perhaps try a hard reset in the relevant long coding section?

Thank you for your reply. Could you explain to me how to do it? I’m a beginner.

@Dawid93 check in 6D module Adaptation, line Activation using rear lid remote unlocking switch-Tap function for closing

Do you have this visible?

Unfortunately not.

8 hours ago, Dawid93 said:

Thank you for your reply. Could you explain to me how to do it? I’m a beginner.

Go to long coding, boot lid and then scroll to bottom and select hard reset.

4 hours ago, Binx1310 said:

Go to long coding, boot lid and then scroll to bottom and select hard reset.

Long coding

6D bootlid

Hard reset