Does anybody activated  teardrop wiping on superb 3 2016?

36 minutes ago, Seba800 said:

teardrop wiping on superb 3 2016

it were done also on my previous MY16, but i haven't saved instructions

 

there are from MY23 Mk3.FL, must be similar

Tear Drop Wipe For Front Wipers

09 Central Electrics

            Subsystem: 48x LL 221122

            Long coding

                        164DDD

            ->         1E4DFD

            -> Byte 0

                        Bit 3 "Adaptative Post/Tear Wiping Active"

            -> Byte 2

                        Bit 5 "Post/Tear Wiping Active"

or         Adaptation

            -> Front_wiper

            ---> Traenenwischen Front Status:

                        not active        ->         active

 

I´ve activated both front and rear raindrops wiping on my MY17 Estate Mk3.

I can give coding for rear wiper if needed. Just ask.  

what is tear drop wipe?

@IulianE

one extra wipe with few seconds delay after windscreen washer

Hello i just wanted to share this, today i have enabled anti theft system in my superb III i did it with obd11.

 

1º go to long coding 09 (Central electrics)

byte 12 bit 0 - active

if your bcm does not accept long coding go to the next step

2º go to adaptation in 09 (central electrics)

search for anti-theaft device

Diebstahlwarnanlage -  active/enable (this is the substitute for not having long coding)

Akustischer Alarm Signalhorn - active/enable

WA Alarmverzoegerung - driver door contact thatcham

DWA Camper Modus: active/enable

Sirenen Alarmzahl: 10 Alarme

Verzoegerung Panikalarm,2 sekunden verzoegerung

 

My car is 2016 superb but has a newer bcm and gateway so so no longcoding in bcm for me

 

 

 

 

Haven't read all the pages, but could Amundsen MIB3 be tweaked so it displays the map on both the VC and the infotainment?

Is there anyone that coded esc to off when holding the button instead of esc sport? 

Would like to have esc sport with a push of the button and esc off when holding it in. 

 

I'm using obdeleven and not vcds though, saw that this was a vcds thread but i took a chance asking anyway 🙃

Can be adjusted in STG 03.

bytes 29

Adjust the last number in the hex value.

??6 ESC on / ESC Sports / ESC off

??7 ESC on / ASR off / ESC off

??9 ESC on / ASR off / ESP Sport

 

 

Whether VCDS or OBD11 ... is the same for both. Only the surface is a bit different.

Edited 20 July, 20232 yr by Lutz_91

Hello,

I activated the change of the ambient lighting in the different driving modes. I want to ask how can I change the profile color to "Normal" from the menu. 

 

 

 

 

 

 

Is it possible to code front DRLs as indicators on non-Matrix LEDs? I have the standard LEDs which have amber halogen bulbs as indicators but DRLs are white all the time and do not blink.

Probably. But a flashing white light isn’t an indicator. You won’t be able to change the colour of the flash either. 

2 minutes ago, SC03OTT said:

Probably. But a flashing white light isn’t an indicator. You won’t be able to change the colour of the flash either. 

Ah, okey. So there is separate amber light strip in Matrix LEDs to do the amber flashing?

23 minutes ago, yea said:

Ah, okey. So there is separate amber light strip in Matrix LEDs to do the amber flashing?

As far as I'm aware they beam LEDs into a Plexiglass which are controlled by independent LEDs, that way they can use the same strip but have different LEDs

I wonder could you have alternate flashing of the DRL and the indicator bulb? I had that on a 2017 FL Octavia and it made the car much more visible as the standard bulb was very difficult to see especially in sunny conditions. 

1 hour ago, j caff said:

I wonder could you have alternate flashing of the DRL and the indicator bulb? I had that on a 2017 FL Octavia and it made the car much more visible as the standard bulb was very difficult to see especially in sunny conditions. 

Well, it made it more visible because it was all blinking like a Christmas tree, thus taking attention of other road users to your Christmas tree instead of paying attention to other road conditions and users, thus lowering overall safety. My opinion. Btw. I am quite sure car with this turned on should not pass MOT, at least here in Slovenia it would fail.

If the visibility and safety is priority, the safe way is to lower drl luminosity when turn signal is on, as old Audis had. Thus turn signal is more visible, no Christmas tree and there is still some visibility of the drl led, thus also car is still visible. Again, my opinion.

Or you can go full Turkish way with blinking rear brake lights, front fog light, etc. Though it doesn’t mean it is smart or nice looking, if it is possible.

Edited 25 August, 20232 yr by mtl

Yeah. The bad earth look isn’t great. Avoid. 

3 minutes ago, SC03OTT said:

Yeah. The bad earth look isn’t great. Avoid. 

Definitely agree.

 

I ordered a pair of these https://www.aliexpress.com/item/32833631116.html. Hopefully they'll look a bit more modern/sharp than the halogens...

I would recommend to go Osram route ;).

Edited 25 August, 20232 yr by mtl

Hello,

 

Please for your help I enabled the following coding for DRL's & Eyelashes, but not without success.

 

1 minute ago, plamen_333 said:

Hello,

 

Please for your help I enabled the following coding for DRL's & Eyelashes, but not without success.

 

If your car is facelift it's not possible anymore 

16 minutes ago, Agustnr said:

If your car is facelift it's not possible anymore 

The car is a 2018 year.

1 hour ago, plamen_333 said:

Hello,

 

Please for your help I enabled the following coding for DRL's & Eyelashes, but not without success.

 

 

U need to have version B headlights, otherwise the eyelash coding won't work.

Have u checked this physically?

 

Those r instructions I created, and I've clearly stated that u need Version B.

if anyone is interested, below is a PDF I created of the various code changes I've made to my Superb (MY17) over the years.

whilst some instructions r done with VCDS, and others with OBDEleven, the steps r essentially the same regardless of the tool - just the screens look different.

 

this will work on 2015 to 2019 Superb.

it won't work on facelift (2019 after) Superb, or at least there will b differences, which i can't assist with. 

 

enjoy 🙂

 

Coding - Superb MK3 - v3.1.pdf

@JR RS I can send you mines if you want to compile them. I have some more:

- Enable Ambient lights coupled with DCC Driving mode

- Enable Easy Entry

- Enable rain drops wiping on both front a rear wipers

- Activate Emergency Brake lights flashing (on brake bulbs)

- Activate Emergency Brake lights flashing (on direction bulbs)

- Activate fan blowing speed in AUTO mode

- Activate Off Road mode on Columbus

- Disable DRLs upon hand brake activation

- Adjust Autohold brake release (Early / Normal / Late) 

- Adjust Corner lights deactivation speed.

 

I just need to translate them in English.